LINK AS 2387720 - Caterpillar

Attach Tooling (C) to planetary carrier (82) .
Attach a suitable hoist and lifting chains to Tooling (C) .
Use the hoist in order to remove planetary carrier (82) from output shaft assembly (101). The weight of planetary carrier (82) is 52 kg (115 lb).
Illustration 63 g00853650
Remove sun gear (102) from output shaft (101) .
Illustration 64 g00853660
Remove rotating hub (103) from output shaft assembly (101). The weight of rotating hub (103) is 20 kg (45 lb).
Illustration 65 g00853669
Remove dowel (105) from output shaft assembly (101) .
Remove one bearing sleeve (104) from each end of output shaft assembly (101). The weight of output shaft assembly (101) is 27 kg (60 lb).
Illustration 66 g00853845
Use Tooling (G) in order to remove retaining ring (106) from planetary carrier (82) .
Illustration 67 g00853888
Use Tooling (E) in order to drive ball bearing (107) from planetary carrier (82) .
Illustration 68 g00853916
Drive spring pin (108) inside planetary shaft assembly (109) .
Remove planetary shaft assembly (109) from planetary carrier (82) .
Illustration 69 g00853954
Remove two thrust discs (110), planetary gear (111), roller bearing (112), and spring pin (108) from planetary shaft assembly (109) .
Repeat steps 108 through 110 in order to remove the remaining planetary gears (111) from carrier (82) .
Illustration 70 g00853981
Remove three O-ring assemblies (113) from support housing (114) .
Illustration 71 g00854006
Remove three dowels (115) from support housing assembly (114) .
Illustration 72 g00854060
Turn over support assembly (114), as shown.
Remove seven bolts and washers (116) from bearing cage (117) .
Illustration 73 g00854073
Install three 3/8-16 NC forcing screws in order to separate bearing cage (117) from support housing assembly (114) .
Remove dowel (118) and plug (119) .
Remove bearing cage (117) from support housing assembly (114) .
Illustration 74 g00854105
Remove retaining ring (120) from bearing cage (117) .
Illustration 75 g00854117
Use Tooling (H) in order to remove ball bearing (121) from bearing cage (117) .
Remove two O-ring seals (122) from bearing cage (117) .