2512655 LINK & BEARING AS Caterpillar parts
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E L VG, 365C, 365C L, 385C
Rating:
Alternative (cross code) number:
CA2512655
251-2655
2512655
CA2512655
251-2655
2512655
Weight: 440 pounds 199 kg.
EXCAVATOR, MOBILE HYD POWER UNIT,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
This part in 2 request:
Show.
This information for suppliers only!
2024-10-25
2022-09-29
Compatible equipment models: 2512655:
Information:
No power to the data radioProbable Causes
Display not turned on
Fuse blown or Circuit Breaker Open
Failed AccuGrade Radio
MPT or Power Jumper
Power Module
Damaged harness or connectorNote: The D8T and D9T do not use a power module. Power is supplied directly to the AccuGrade radio via a fuse.Problem Isolation
Test Step 1. VERIFY THE DISPLAY WILL POWER UP
Ensure the battery disconnect switch and the key start switch are in the ON position.
Turn on the display.Expected Result:The display turns ON.Results:
OK - The display turns ON. Proceed to Test Step 2.
NOT OK - The display does NOT turn "ON".Repair: Perform the "Display Does Not Turn On" procedure. Stop.Test Step 2. VERIFY THE ACCUGRADE RADIO POWERS UP.
Verify that the power LED on the AccuGrade radio is illuminated.Expected Result:The power LED on the AccuGrade radio is illuminated.Results:
OK -The power LED on the AccuGrade radio is illuminated.Repair: The problem was caused by the diplay being turned off. Return the machine to service.Stop.
NOT OK - The power LED on the GPS receiver(s) is not illuminated. Proceed to Test Step 3.Test Step 3. CHECK THE POWER TO THE GPS RECEIVERS.
Disconnect the harness connectors from the from AccuGrade radio connector.
Measure AccuGrade radio.Expected Result:The measured voltage is approximately machine voltage.Results:
OK - The measured voltage is approximately machine voltage. Repair: The AccuGrade radio has failed. Replace the failed AccuGrade radio.Stop.
NOT OK - The voltage is not approximately machine voltage. Proceed to Test Step 4.Test Step 4. CHECK FUSE OR CIRCUIT BREAKER.
Check the fuse or circuit breaker.Note: Use the machine schematic in order to identify the correct fuse or circuit breaker.Expected Result:The fuse or circuit breaker is "OK".Results:
OK - The fuse or circuit breaker is "OK". Proceed to Test Step 5.
NOT OK - The fuse or circuit breaker have failed.Repair: Replace the fuse or circuit breaker.Stop.Test Step 5. CHECK FOR AN OPEN POWER JUMPER OR A FAILED MPT IN THE POWER CIRCUIT IN THE HARNESS.
Use the AccuGrade Electrical Schematic for the machine in order to determine if a power jumper or an MPT is used.
Disconnect the power jumper or MPT.
Place a jumper between pin B and pin C at the connector of the display harness.
Turn on the displayExpected Result:The AccuGrade radio powers upResults:
OK - The power jumper or the MPT has failed.Repair: Replace the power jumper or the MPT.Stop.
NOT OK - The AccuGrade radio does not power up. The power jumper or the MPT are not the cause of the failure. Proceed to Test Step 6.Test Step 6. CHECK FOR A SHORTED POWER CIRCUIT IN THE HARNESS.
Check the display harness for a short circuit condition.Note: Use the machine schematic to
Display not turned on
Fuse blown or Circuit Breaker Open
Failed AccuGrade Radio
MPT or Power Jumper
Power Module
Damaged harness or connectorNote: The D8T and D9T do not use a power module. Power is supplied directly to the AccuGrade radio via a fuse.Problem Isolation
Test Step 1. VERIFY THE DISPLAY WILL POWER UP
Ensure the battery disconnect switch and the key start switch are in the ON position.
Turn on the display.Expected Result:The display turns ON.Results:
OK - The display turns ON. Proceed to Test Step 2.
NOT OK - The display does NOT turn "ON".Repair: Perform the "Display Does Not Turn On" procedure. Stop.Test Step 2. VERIFY THE ACCUGRADE RADIO POWERS UP.
Verify that the power LED on the AccuGrade radio is illuminated.Expected Result:The power LED on the AccuGrade radio is illuminated.Results:
OK -The power LED on the AccuGrade radio is illuminated.Repair: The problem was caused by the diplay being turned off. Return the machine to service.Stop.
NOT OK - The power LED on the GPS receiver(s) is not illuminated. Proceed to Test Step 3.Test Step 3. CHECK THE POWER TO THE GPS RECEIVERS.
Disconnect the harness connectors from the from AccuGrade radio connector.
Measure AccuGrade radio.Expected Result:The measured voltage is approximately machine voltage.Results:
OK - The measured voltage is approximately machine voltage. Repair: The AccuGrade radio has failed. Replace the failed AccuGrade radio.Stop.
NOT OK - The voltage is not approximately machine voltage. Proceed to Test Step 4.Test Step 4. CHECK FUSE OR CIRCUIT BREAKER.
Check the fuse or circuit breaker.Note: Use the machine schematic in order to identify the correct fuse or circuit breaker.Expected Result:The fuse or circuit breaker is "OK".Results:
OK - The fuse or circuit breaker is "OK". Proceed to Test Step 5.
NOT OK - The fuse or circuit breaker have failed.Repair: Replace the fuse or circuit breaker.Stop.Test Step 5. CHECK FOR AN OPEN POWER JUMPER OR A FAILED MPT IN THE POWER CIRCUIT IN THE HARNESS.
Use the AccuGrade Electrical Schematic for the machine in order to determine if a power jumper or an MPT is used.
Disconnect the power jumper or MPT.
Place a jumper between pin B and pin C at the connector of the display harness.
Turn on the displayExpected Result:The AccuGrade radio powers upResults:
OK - The power jumper or the MPT has failed.Repair: Replace the power jumper or the MPT.Stop.
NOT OK - The AccuGrade radio does not power up. The power jumper or the MPT are not the cause of the failure. Proceed to Test Step 6.Test Step 6. CHECK FOR A SHORTED POWER CIRCUIT IN THE HARNESS.
Check the display harness for a short circuit condition.Note: Use the machine schematic to
Caterpillar parts catalog:
Parts link Caterpillar catalog:
3012287
LINK AS-TRACK
330D L, 330D MH, 345C, 345C L, 345C MH, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 568 FM LL
330D L, 330D MH, 345C, 345C L, 345C MH, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 568 FM LL
2368893
LINK AS-TRACK
325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 345C, OEMS
325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 345C, OEMS
2512661
LINK & BEARING AS
385C, 385C L
385C, 385C L
2512664
LINK & BEARING AS
365C, 385C, 385C L
365C, 385C, 385C L
2736882
LINK AS
385C, 385C L
385C, 385C L
2512658
LINK & BEARING AS
365C, 365C L, 374D L, 374F L, 385C
365C, 365C L, 374D L, 374F L, 385C
2964361
LINK-TRACK
365C, 365C L, 365C L MH, 374D L, 374F L
365C, 365C L, 365C L MH, 374D L, 374F L
2964362
LINK-TRACK
365C, 365C L, 365C L MH, 374D L, 374F L
365C, 365C L, 365C L MH, 374D L, 374F L
2198348
LINK & BEARING AS
365C, 365C L, 374D L, 374F L
365C, 365C L, 374D L, 374F L
2736872
LINK AS
365C, 365C L
365C, 365C L
2552364
LINK-TRACK
345C, 345C L, 345C MH
345C, 345C L, 345C MH
2552365
LINK-TRACK
345C, 345C L, 345C MH
345C, 345C L, 345C MH
2123094
LINK AS
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 385C
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 385C
1483307
LINK
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 385C
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 385C
1421804
LINK-TRACK
345B II, 345C, 345C L, 365B, 365B II, 365B L, 365C, 365C L, 365C L MH, 385C
345B II, 345C, 345C L, 365B, 365B II, 365B L, 365C, 365C L, 365C L MH, 385C
1421803
LINK-TRACK
345B II, 345C, 345C L, 365B, 365B II, 365B L, 365C, 365C L, 365C L MH, 385C
345B II, 345C, 345C L, 365B, 365B II, 365B L, 365C, 365C L, 365C L MH, 385C
4574716
LINK AS-GRAPPLE
CTV20
CTV20
4380655
LINK AS-GRAPPLE
CTV20
CTV20
3909143
LINK-TRACK
345C, 345C L, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L HVG, 349E L VG, 349F L
345C, 345C L, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L HVG, 349E L VG, 349F L
3909144
LINK-TRACK
345C, 345C L, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L HVG, 349E L VG, 349F L
345C, 345C L, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L HVG, 349E L VG, 349F L
3059361
LINK-TRACK
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L VG
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L VG
3059362
LINK-TRACK
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L VG
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E L, 349E L VG
2964360
LINK-TRACK
385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L
385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L
2964359
LINK-TRACK
385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L
385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L