2789373 LINK & BEARING AS Caterpillar parts
315D L, 316E L, 318D L, 318D2 L, 318E L
Rating:
Alternative (cross code) number:
CA2789373
278-9373
2789373
CA2789373
278-9373
2789373
Weight: 195 pounds 88 kg.
EXCAVATOR,
Number on catalog scheme:
9
For full view, you need register
Information:
Table 1
Diagnostic Trouble Code for Water in Fuel
CDL Code Description Information About the Code
E232-1 High Fuel/Water Separator Water Level : Level 1 Water has been detected in the fuel that is contained in the fuel/water separator bowl. The water has been present for at least 45 seconds.
The warning lamp will come on.
E232-2 High Fuel/Water Separator Water Level : Level 2 Water has been detected in the fuel that is contained in the fuel/water separator bowl. The water has been present for at least 1 hour.
The warning lamp will come on. Note: Visual identification of water in the bowl may be impossible. Water may turn dark yellow in color in the fuel system. The similarity in color would prevent the ability to differentiate the water from the fuel.Recommended Actions
Note: Complete the procedure in the order in which the steps are listed.
Table 2
Troubleshooting Test Steps Values Results
1. Drain the Fuel/Water Separator Bowl
A. Turn the ignition key to the OFF position.
B. Drain the fuel/water separator bowl. Refer to the Operation and Maintenance Manual, "Fuel System Primary Filter/Water Separator - Drain".
C. If necessary, prime the fuel system. Refer to the Operation and Maintenance Manual, "Fuel System - Prime".
D. Turn the ignition key to the ON position. Do not start the engine. Wait for 1 minute.
Fuel/water separator
Result: The "Water-In-Fuel" warning disappears within 1 minute.
Proceed to Test Step 2.
Result: The "Water-In-Fuel" warning remains on.
Proceed to Test Step 3.
2. Confirm that there is no Water in the Fuel
Run the engine for 5 minutes.
Water in fuel
Result: The "Water-In-Fuel" warning does not reappear within the 5 minutes.
Return the unit to service.
Result: The "Water-In-Fuel" warning reappears within the 5 minutes.
The fuel supply is contaminated with water. Drain the fuel tank and then fill the fuel tank with clean fuel.
Repeat the procedure from Test Step 1.
3. Water-In-Fuel Switch
A. Check the operation of the Water-In-Fuel switch. Refer to Troubleshooting, "Water In Fuel - Test".
Water in fuel switch
Result: The Water-In-Fuel switch required a repair.
Repeat the procedure from Test Step 1.
Result The Water-In-Fuel switch is OK.
The fuel supply is contaminated with water. Drain the fuel tank and then fill the fuel tank with clean fuel.
Repeat the procedure from Test Step 1.
Caterpillar parts catalog:
Parts link Caterpillar catalog:
2670055
LINK & BEARING AS
315D L, 316E L, 318D2 L, 318E L
315D L, 316E L, 318D2 L, 318E L
307D, 308D, 308E2 CR
3056799
LINK AS
307D, 308D, 308E2 CR
307D, 308D, 308E2 CR
3056800
LINK GP-THUMB
307D, 308D, 308E2 CR
307D, 308D, 308E2 CR
2969478
LINK AS
307D, 308D, 308E, 308E CR, 308E SR, 308E2 CR
307D, 308D, 308E, 308E CR, 308E SR, 308E2 CR
2969477
LINK
307D, 308D, 308E, 308E CR, 308E SR, 308E2 CR
307D, 308D, 308E, 308E CR, 308E SR, 308E2 CR
2803135
LINK & BEARING AS
M318D, M318D MH, M322D, M322D MH
M318D, M318D MH, M322D, M322D MH
2803131
LINK AS
M318D, M318D MH, M322D, M322D MH
M318D, M318D MH, M322D, M322D MH
2803169
LINK & BEARING AS
M315D, M316D
M315D, M316D
2803167
LINK AS
M315D, M316D
M315D, M316D
3192243
LINK AS-WIPER
312D, 315D L, 319D
312D, 315D L, 319D
319D, 319D L, 319D LN, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 L, 320E L, 320E LN, 320E LRR, 321D LCR, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D L, 325D, 3...