LINK AS-TRACK 2970129 - Caterpillar

Check if control pattern A (Standard) or control pattern B (Alternate) is selected before operating the machine.Refer to Operation and Maintenance Manual.Failure to understand control functions could result in injury or death.
Joystick Control Selector (If Equipped)
Illustration 1 g03123008
The joystick control selector is located on the left side under the seat.The machine may be equipped with a joystick control selector. The machine control pattern can be varied by turning the valve. Position (A) is the factory setting. This is the standard position. Position (B) is the alternate position. The alternate position allows the operator to change the functions of the joysticks.
Loosen screw (1) .
Move the lever to position (A) or to position (B) .
Tighten screw (1) .Alternate Joystick Control Pattern
Illustration 2 g02725473
Left-hand joystick
BOOM LOWER (1) - Move the joystick to this position in order to lower the boom.
SWING RIGHT (2) - Move the joystick to this position in order to swing the upper structure to the right.
BOOM RAISE (3) - Move the joystick to this position in order to raise the boom.
SWING LEFT (4) - Move the joystick to this position in order to swing the upper structure to the left. HOLD (9) - When you release the joystick from any position, the joystick will return to the HOLD position. Movement of the structure will stop.
Illustration 3 g02725474
Right-hand joystick
STICK OUT (5) - Move the joystick to this position in order to move the stick outward.
BUCKET DUMP (6) - Move the joystick to this position in order to dump the bucket or the work tool.
STICK IN (7) - Move the joystick to this position in order to move the stick inward.
BUCKET CLOSE (8) - Move the joystick to this position in order to close the bucket or the work tool. HOLD (9) - When you release the joystick from any position, the joystick will return to the HOLD position. Movement of the structure will stop.Two functions may be performed at the same time by moving the joysticks diagonally.