LINK GP 2A6945 - Caterpillar

Removal Procedure
Start By:
Release the pressure in the hydraulic oil system. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release". Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.Right Side
Illustration 1 g01241624
Remove handle (1) and bolt (2).
Illustration 2 g01241630
Illustration 3 g01241631
Remove plugs (3) and lower rubber boot (4).
Remove bolt (6). Repeat for the other side. Remove cover (5).
Illustration 4 g01241634
Disconnect harness assembly (7) and hose assemblies (8).
Illustration 5 g01241635
Remove bolts (9) and pilot valve (10) for the backhoe. Left Side
Illustration 6 g01241695
Remove bolt (1).
Illustration 7 g01241697
Illustration 8 g01241698
Remove plugs (2) and lower rubber boot (3).
Remove bolt (5). Repeat for the other side. Remove cover (4).
Illustration 9 g01241699
Disconnect harness assembly (9) and hose assemblies (8). Remove bolts (7) and pilot valve (6) for the backhoe.