LINK AS 3385051 - Caterpillar

Illustration 24 g01952846
Route hose (13) through five clips (19) that were added in Step 14. Attach hose (13) to ripper grease block (1). Tighten bolt (30), bolt (31), and bolt (32) .
Illustration 25 g01948287
Starting from block (1), attach ten clips (19) to the ripper frame. Clips (19) are for hose (6), hose (8), hose (9), and hose (12) on the right hand ripper frame.
At the first boss, attach two clips (19) back to back, with one bolt (31), washer (27), and one spacer (33) .
At the second boss, attach two clips (19) back to back, with one bolt (30), one washer (27) and one spacer (35)
At the third boss, attach two clips (19) 180° apart, with one bolt (32), one washer (27), and one spacer (33) .
At the fourth boss, attach two clips (19) 180° apart, with one bolt (32) and one washer (27) .
At the fifth boss, attach two clips (19) 180° apart, with one bolt (31) and one washer (27) .
Illustration 26 g01948901
Remove bolt (N). Install bracket (16) with bolt (N) .
Attach clip (18) and clip (19) with bolt (34) and washer (25). Leave bolt (34) loose.
Route hose (12) through clip (18) .
Illustration 27 g01948902
Route hose (12) through five clips (19) on the ripper frame. Attach hose (12) to ripper grease block (1). Refer to Step 23.
Illustration 28 g01948907
Attach hose (12) to the connector on pin assembly (17) on the left side of the machine.
Illustration 29 g01948913
Route hose (6) through five clips (19). Attach hose (6) to ripper grease block (1). Refer to Step 23.
Illustration 30 g01948917
Route hose (6) through clips (19). Refer to Step 13.
Illustration 31 g01951948
Attach hose (6) to the head end of the tilt cylinder.
Illustration 32 g01952010
Route hose (9) through clip (19). Tighten bolt (34). Refer to Step 24.
Illustration 33 g01951978
Route hose (9) through five clips (19). Attach hose (9) to ripper grease block (1) .
Illustration 34 g01953282
Attach hose (9) to the connector at the existing grease block on the right side of the machine.
Illustration 35 g01954074
Route hose (8) on the ripper frame through five clips (19) that were installed in Step 23. Attach hose (8) to the connector at the rod end of the right tilt cylinder. Attach hose (8) to ripper grease block (1) .
Illustration 36 g01954502
Use four bolts (29) and four washers (26) to install plate (3). Attach clip (19) that was added in Step 11 to plate (3). Tighten bolt (30) .
Grease the fittings. Raise the ripper and lower the ripper slowly in order to ensure that all of the hoses have enough slack. Tighten the bolts. Refer to Step 13, Step 14, and Step 23.