LINK & BEARING AS 3895047 - Caterpillar

Table 3
Part Number Standard Weight (lb) Target Weight (lb) Actual Weight (lb) Status
106-3969 9.6 10.2 9.8 pass
4W-5228 16 16.6 17.1 fail
7W-5317 4.8 5.4 4.7 pass
9Y-7662 22.2 22.8 30.3 fail
6I-2499 3.4 4.0 4.0 pass
7Y-1323 7.8 8.4 8.9 fail This table shows when an air filter element passes or an air filter element fails.
Illustration 42 g01158959
An example of a box with a light.
Illustration 43 g01158960
An example of inspecting an air filter element by using a box with a light.
Note: Caterpillar recommends using a 500 W to 1000 W clear light bulb. (2) Place the air filter element into the box to inspect the filter paper. Turn on the clear light bulb to inspect the air filter element.Note: Finding the small holes and small tears can be difficult. (3) Slowly spin the air filter element and move the bulb up and down. Replace an air filter element with thin filter paper or tears.
Illustration 44 g01158962
Typical damage to the element of a radial seal air filter
Do not use this air filter again.
Illustration 45 g01158963
A typical example of a reusable element of an air filter with an axial seal.
Reuse this air filter until a replacement can be installed.
Illustration 46 g01158964
A typical example of dust on the end of the clean side of the air filter element.
Illustration 47 g01158965
An example of a hole in the air filter paper.
Do not use this air filter again. (4) If the air filter element fails, enter the information into the certified system by using the bar code.
Illustration 48 g01158967
Putting a bar code on the air filter element
(5) Use the certified system by using the bar code to identify the air filter element.
Illustration 49 g01158970
Cleaning the air filter element with a mild cleaner
Note: Apply 138-8448 Plastic Protectant to all seals and surfaces of axial air filter elements and radial air filter elements.Note: Do not allow the filter paper to get wet. (6) Position the air filter element into the fixture. Visually inspect the air filter element for final acceptability. Use a rag with 138-8448 Plastic Protectant to clean the air filter element. Apply 138-8448 Plastic Protectant to all the sealing surfaces.Note: Write the reason that the air filter element failed in your records and the customer records. (7) Use the system of bar codes to record if the air filter element passed or if the element failed.
Illustration 50 g01158971
The label that is used to identify each air filter element that has been packaged
Note: Make sure that the correct labels for identification are placed with the corresponding air filter elements. (8) If the air filter element passes final inspection, then print the label that identifies the air filter element.