LINK AS 4695568 - Caterpillar

The coolant level must be to the correct level in order to check the coolant system. The engine must be cold and the engine must not be running. After the engine is cool, loosen the pressure cap in order to relieve the pressure out of the cooling system. Then remove the pressure cap.The level of the coolant should not be more than 13 mm (0.5 inch) from the bottom of the filler pipe. If the cooling system is equipped with a sight glass, the coolant should be to the proper level in the sight glass.Test Tools For The Cooling System
Table 1
Required Tools
Part Number Part Name Qty
4C-6500 Digital Thermometer 1
9S-8140 Pressurizing Pump 1
1U-7297 Coolant/Battery Tester 1
1U-7298 Coolant/Battery Tester 1
Making contact with a running engine can cause burns from hot parts and can cause injury from rotating parts.When working on an engine that is running, avoid contact with hot parts and rotating parts.
Illustration 2 g00300241
4C-6500 Digital Thermometer
The 4C-6500 Digital Thermometer is used in the diagnosis of problems that cause overheating or overcooling in the engine. This tool can be used to check the temperature in several areas of the cooling system. The testing procedure is in Tool Operating Manual, NEHS0554.
Illustration 3 g00286369
9S-8140 Pressurizing Pump
The 9S-8140 Pressurizing Pump is used to test the filler caps. This pressurizing pump is also used to pressure test the cooling system for leaks.
Illustration 4 g00439083
1U-7297 Coolant/Battery Tester or 1U-7298 Coolant/Battery Tester
Check the coolant frequently in cold weather for the proper glycol concentration. Use either the 1U-7297 Coolant/Battery Tester or the 1U-7298 Coolant/Battery Tester in order to ensure adequate freeze protection. The testers are identical except for the temperature scale. The testers give immediate, accurate readings. The testers can be used for antifreeze/coolants that contain ethylene or propylene glycol.Making the Correct Antifreeze Mixtures
Do not add pure antifreeze to the cooling system in order to adjust the concentration of antifreeze. The pure antifreeze increases the concentration of antifreeze in the cooling system. The increased concentration increases the concentration of dissolved solids and undissolved chemical inhibitors in the cooling system. Add an antifreeze and water mixture in the concentration which provides the desired freeze protection. Use the following chart in order to determine the correct concentration of antifreeze in water to use.
Table 2
Antifreeze Concentrations For Freeze Protection
Temperature Concentration
Protection to −15 ° C (5 ° F) 30% antifreeze and 70% water
Protection to −23 ° C (−9 ° F) 40% antifreeze and 60% water
Protection to −37 ° C (−35 ° F) 50% antifreeze and 50% water
Protection to −51 ° C (−60 ° F) 60% antifreeze and 40% water Cooling System Conditioner
Supplemental cooling system additive contains alkali. To prevent personal injury, do not drink, avoid contact with the skin and eyes.
All water is corrosive at engine operating temperature. The cooling system should be protected with a 3% to 6% concentration of cooling system conditioner at all times.Caterpillar does not recommend the use of cooling system solutions that are intended to stop leaks.Use of these products