LINK 4V2882 - Caterpillar

Illustration 2 g03192137
Illustration 3 g03192196
Illustration 4 g03192217
Illustration 5 g03193177
Installation Procedure
Illustration 6 g03195858
(A) 206-3336 Pilot Valve Gp
Locate pilot valve (A) under the cab floor.ReferenceFor more information refer to Special Instruction, GEHS0119, "Installation Procedure for the 239-8693 Hydraulic Pedal Control Gp "
Illustration 7 g03195918
(A) 206-3336 Pilot Valve Gp (1) 4I-1704 Hose As (2) 087-4402 Hose As (8) 148-8378 Elbow As (9) 148-8407 Plug As
Insert plug (9) into the "R1" port of valve (A) .
Insert elbow (8) into the "R2" port of valve (A) .
Illustration 8 g03196116
(1) 4I-1704 Hose As (2) 087-4402 Hose As (4) 164-5629 Fitting As (5) 309-5769 Pressure Switch
Insert fitting (4) into the "R3" port of valve (A) .
Fasten pressure switch (5) on to fitting (3), located on port "R3". Tighten to a torque of 29 N m (21 lb ft).
Insert connector (6) into port "T" of valve (A) .
Insert connector (3) into port "P" of valve (A) .
Illustration 9 g03197366
(A) 206-3336 Pilot Valve Gp (B) 168-9759 Block (1) 4I-1704 Hose As (2) 087-4402 Hose As (7) 148-8353 Elbow As
Locate valve block (B) directly behind the travel pedal valves, under the cab floor. Fasten each of elbow (7) into port "PB3" and port "DB3" of valve block (B) .
Fasten the angled end of hose (2) on to connector (6) located on port "T" of valve (A) .
Route straight end of hose (2) over to valve block (B) and connect to elbow (7) located on port "DB3".
Fasten the angled end of hose (1) on to connector (3) located on port "P" of valve (A) .
Route straight end of hose (1) over to valve block (B) and connect to elbow (7) located on port "PB3".
Unless specified, tighten all hardware and fittings to standard torque.ReferenceTorque Specifications, SENR3130, "Torque Specifications"