LINK AS-TRACK 5243181 - Caterpillar

Illustration 4 g06007398
Switch mounting location options
Wires 2 and 3: There will be an existing harness already installed inside the generator-mounted EMCP panel. The wiring connector will be labeled as "ether". A 155-2267 Connector Plug As will already be in this harness (unused due to ether not being installed) located near the cutout for the ether toggle location. Remove the wire in A (R774-PH1 GY-18) and relocate to pin C. The existing wire in pin B will need to be wired as is. Plug this connector into the toggle switch.For the wall-mounted EMCP panel wires 2 and 3 will need to be run and wired into the 155-2267 Connector Plug As.
Install a 490-6464 film next to the face of the EMCP panel next to the toggle switch or rocker switch.Wiring for Rocker Switch
Illustration 5 g06007440
Rocker Switch Schematic
Note: For C175 engines wire1is already present in the existing harness to the generator interface connection for Generator-mounted EMCP Panels & the harness for the Remote Mounted EMCP Panel, proceed to step #2.
Wire 1: Cut an 18 AWG wire and crimp a 9X-3402 Connector Socket on each end or a 180-9340 Connector Socket on one end depending on the EMCP panel used. Insert one end of the wire with 9X-3402 Connector Socket into the engine ECM connector J1, pin 22, and the other end will run along the harness up to the control box and insert into pin 9 at the connector interface into the generator control box. The new wire will need to be run externally and secured to the existing harness using tie straps or some other means.
Illustration 6 g06007450
Generator Interface Connection
For Wall Mounted EMCP the new wire will need to run along the interconnect harness to the remote mounted EMCP Panel. The wire end with the 180-9340 Connector Socket will be inserted into the 1U-9458 Connector military style connector that connects to the EMCP panel.Note: The wire with the 180-9340 Connector Socket will need to be inserted into the connector in one of the open holes that is not being used. Pin 51 is suggested as this pin location is for the optional Ether wire.
Illustration 7 g06007478
Wall Mounted Cabinet
(3) Wall-mounted Cabinet
(4) Engine interface connector ET-C5 connects to Connector L-C1
Depending on optional attachments that were added to the EMCP panel, there will be an existing area that can be used to mount rocker switch. The EMCP panel will need to be cutout to accept the rocker switch.
Illustration 8 g06007488
Switch Mounting Location Options
Illustration 9 g06007568
Panel Opening (Mount Vertical)
Once the rocker switch location has been cutout, then mount the rocker switch to the panel.
Wires 4 and 5: There will be an existing harness already installed inside the generator-mounted EMCP panel. The wiring connector will be labeled as "ether". A 155-2267 Connector Plug As will already be in this harness (unused due to ether not being installed) located near the cutout for the ether toggle location. Remove the connector from the wires (Note: the wires can be cut from the connector as the terminals will also not