LINK 5249623 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 138-7576 Link Bracket 2
1U-9199 Lever Puller Hoist 1
E 1P-1833 Bearing Puller Adapter 1
5P-4776 Tool Stud 1
9U-6833 Nut 1
1U-5230 Hand Hydraulic Pump 1
4K-0684 Hard Washer 1
5P-5247 Hydraulic Puller 1
Illustration 1 g01021911
Lower the temperature of bearings (19). Use Tooling (E) to install bearings (19).
Illustration 2 g01021934
Install thrust washers (17) and seal (18).
Illustration 3 g01021815
Lower the temperature of pins (11) and (12).
Install O-ring seals (15) and seals (14).
Install wheel spindle (10).
Install pins (11) and (12). Install rings (13) and (16). Pins (11) and (12) must protrude to the dimension of 2.0 0.5 mm (0.08 0.02 inch).
Illustration 4 g01021810
Position steering cylinder (9) to the original location.
Install nut (8). Tighten nut (8) to a torque of 140 14 N m (103 10 lb ft). Install cotter pin (7).
Illustration 5 g01021808
Install washer (5) and bolt (4). Install bolt (6).
Illustration 6 g01021806
Position tie rod (3) to the original location.
Install nut (2). Tighten nut (2) to a torque of 120 N m (89 lb ft). End By:
Remove the wheel. Refer to Disassembly and Assembly, "Wheel - Remove and Install".