LINK GP 5288256 - Caterpillar

Horn - Push the horn button in order to sound the horn. Use the horn to alert personnel or signal personnel. Propel Control Lever (12)
FORWARD - Push the propel control lever away from the operator in order to move the compactor forward. In order to cause the machine to move faster, push the lever farther.NEUTRAL - Move the propel control lever to the center STOP position in order to stop the machine.REVERSE - Pull the propel control lever toward the operator in order to move the machine in reverse. In order to cause the machine to move faster, pull the lever farther.Note: If you release the propel control lever, the propel control lever will stay in the same position.
Come to a complete stop before changing direction of travel.
Propel Speed Range Control (13)
Propel Speed Range Control - The control allows the machine to operate in the HIGH range or the LOW range.
LOW - In order to place the machine in LOW range, move the propel speed range control forward. LOW range reduces the overall speed of the machine. This increases the operator control.
HIGH - In order to place the machine in HIGH range, move the propel speed range control rearward. HIGH range increases the speed of the machine. HIGH range is used to move the machine from one job site to another job site. Note: Before you start up a slope or down a slope, LOW range is recommended for optimal performance and maximum control. Do not change the propel speed range control while you go downhill.Parking Brake (14)
Do not engage the parking brake while the machine is moving unless an emergency exists.The use of the parking brake as a service brake in regular operation causes severe damage to the parking brake system.
Note: If the parking brake is used in an emergency, perform a braking system test. See Operation and Maintenance Manual, "Braking System - Test" for instructions.
Parking Brake - In order to apply the parking brake, push the knob downward. In order to release the parking brake, pull the knob upward. Note: In order to propel the machine, the propel lever must be in the NEUTRAL position before you release the parking brake.Light Switches (17)
OFF - Turn the knob to the OFF position in order to turn off the lights.
Parking - Turn the knob to this position in order to turn on the parking lights.
Headlights - Turn the knob to this position in order to turn on the low beam headlights.
Working lights - Turn the knob to this position in order to turn on the working lights. Water Spray Control (18)
Always check the water level in the water tanks before you use the water spray system.Contaminated water in the water tanks can cause performance problems and reliability problems in the water spray system.
The spray system is activated by a three-position switch on the right console.Move the switch forward for continuous spray.Move the switch rearward for intermittent spray.An adjustable intermittent spray is available. Two switches control the intermittent spray.