LINK-MASTER-RH 7T2277 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Guide Bolt (8 mm by 1.25 - 50 mm)     2    
B     187-2718     Filter Wrench As     1    Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Raise the engine hood.
Drain the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Refill Capacities".
Turn the battery disconnect switch to the OFF position.
Illustration 1 g01177396
Remove shield assembly (1) .
Illustration 2 g01177397
Disconnect hose assemblies (2), cables (3), and harness assembly (4) .
Illustration 3 g01177398
Install Tooling (A) .
Use Tooling (B) to remove engine oil filter (8) .
Remove studs (7), bolts (5), engine oil filter base (6), and the gasket.
Illustration 4 g01177402
Remove engine oil cooler (9) and the gasket.
Illustration 5 g01177403
Remove O-ring seals (10) and Tooling (A) .