LINK-TRACK MASTER 9G8739 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     2    
B     -     Guide Bolts     3    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01228877
Position torque converter housing (6) and install bolts (7) .
Illustration 2 g00803903
Install bolts (5) to a torque of 100 20 N m (74 15 lb ft).
Illustration 3 g01222538
Position No. 1 rotating clutch and plate (1). Install bolts (4) to a torque of 12 3 N m (106 26 lb in). Install bolts (3) to a torque of 55 10 N m (40 7 lb ft). End By:
Install the modulating valve. Refer to Disassembly and Assembly, " Modulating Valve (Torque Converter Lockup Clutch) - Remove and Install".
Install the bypass valve. Refer to Disassembly and Assembly, " Bypass Valve - Remove and Install".
Connect the transmission and the torque converter. Refer to Disassembly and Assembly, " Transmission and Torque Converter - Connect".