LINK A.-TRACK 9M0784 - Caterpillar

Attach a suitable lifting device to Tooling (M) (not shown) and pin (19). The weight of pin (19) and Tooling (M) is approximately 215 kg (475 lb). Position pin (19). Attach Tooling (M) and a suitable lifting device in order to install pin (19). Install pin (19).
Illustration 6 g03233256
Install collet (17). Install bolt (16).
Repeat Steps 4 through 6 for opposite side.
After both pins have been fully installed in the K-pin joints, cycle the lift arms. Cycle the lift arms several times from the fully lowered position to the fully raised position. This procedure will center the lift arms in the loader frame. The machine must be sitting level across the width of the machine in order to properly center the lift arms. Check the lift arms in order to confirm that the lift arms are centered in the loader frame.
Illustration 7 g03358604
There should also be gaps between the lift arm and the front frame at all four locations after shimming the pin
Illustration 8 g03358607
Gap is between the retainer plate bolted to the pin and the insert in the front frame at all four locations
Install 246-6613 Retainer Plates on both ends of each A-pin joint. Use 246-6629 Plates, 272-8140 Plates, and 310-1678 Plates behind the retainer plate in order to achieve a gap of 0.75 0.25 mm (0.030 0.010 inch) between the face of the pin cartridge and the back face of the retainer plate. Use 12 137-3301 Bolts and 12 5P-8247 Hard Washers in order to attach each plate.
Illustration 9 g01608357
Illustration 10 g03230261
Attach a suitable lifting device to fender assembly (12). The weight of fender assembly (12) is approximately 159 kg (350 lb). Install fender assembly (12). Install bolts (13) and (14).
Repeat Step 10 for the opposite side of the machine.
Illustration 11 g01616779
Install clips (11). Connect harness assembly (10).
Illustration 12 g01606797
Attach Tooling (A) and Tooling (D) to tilt cylinder (9). The weight of tilt cylinder (9) is approximately 1500 kg (3307 lb). Position tilt cylinder (9) in order to install the pin.
Illustration 13 g01615559
Attach Tooling (N) and a suitable lifting device to pin (8). Position pin (8). Attach Tooling (N) and a suitable lifting device to pin (8). Position pin (8). Extend tilt cylinder (9) in order to install pin (8).
Illustration 14 g01615554
Install collets (7) to both sides. Install bolt (6).
Repeat Steps 14 through 15 for opposite side.
Illustration 15 g01615548
Illustration 16 g01616876
Illustration 17 g01606776
Attach Tooling (A) and a suitable lifting device to tilt link (1). The weight of tilt link (1) is approximately 246 kg (542 lb). Position tilt link (1) in order to install pin (5). Install Tooling (N) in order to install pin (5). Install pin (5).
Install collet (4). Install plugs (3). Repeat for the opposite side. Install bolt (2). End By:
Install the bucket.
Install the lift position sensor.