LINK (LH) 9P3350 - Caterpillar

Removal Procedure
Start By:
Connect steering frame lock. Refer to Disassembly and Assembly , "Steering Frame Lock - Seperate and Connect".
Release the hydraulic system pressure. Refer to Disassembly and Assembly , " Hydraulic System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all harness assemblies, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01238181
Disconnect hose assemblies (3). Remove nuts (1). Remove brake control valve (2). Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 2 g01238181
Position brake control valve (2) and install nuts (1). Connect hose assemblies (3). End By:
Separate steering frame lock. Refer to Disassembly and Assembly , "Steering Frame Lock - Seperate and Connect".