AVSPARE.COM
parts catalog

LINK AS 9R9103 - Caterpillar


9R9103 LINK AS Caterpillar parts 416B, 416C, 428B, 428C, 438B, 438C
Rating:
26
Alternative (cross code) number:
CA9R9103
9R-9103
9R9103
Caterpillar 9R9103 LINK AS
Weight: 44 pounds 20 kg.

Buy LINK AS 9R9103 Caterpillar genuine, new aftermarket tractor parts with delivery
BACKHOE LOADER,

Compatible equipment models: 9R9103:

BACKHOE LOADER  416B   416C   428B   428C   438B   438C   Caterpillar
Number on catalog scheme: 4
  For full view, you need register

Information:


Illustration 1 g01135186
Schematic of the Bucket Cylinder Extend SolenoidThis diagnostic code is associated with the Bucket Cylinder Extend Solenoid. The FMI 03 means that the ECM has determined that the voltage of the solenoid circuit is above normal. The possible causes of the diagnostic code are listed:
The solenoid has failed.
The energize circuit of the solenoid is shorted to the +battery circuit.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1141 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The diagnostic code of CID 1141 FMI 03 will be logged in the internal memory of the Machine ECM.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the solenoid and the ECM.
At the machine harness connector for the ECM, measure the resistance from contact J2-15 (wire K931-GN) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-15 (K931-GN) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE.
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 1141 FMI 03 is active.Expected Result:The CID 1141 FMI 03 is active.Results:
YES - The CID 1141 FMI 03 is active. The problem has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". Stop.
NO - The CID 1141 FMI 03 is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation. Stop.

Caterpillar parts catalog:

Caterpillar parts catalog
416B Backhoe Loader 8ZK00001-05999 (MACHINE) POWERED BY 3054 Engine
416B Backhoe Loader 8ZK06000-11031 (MACHINE) POWERED BY 3054 Engine
428B Backhoe Loader 7EJ06000-09446 (MACHINE) POWERED BY 3054 Engine
428C Backhoe Loader 8RN00001-04088 (MACHINE) POWERED BY 3054 Engine
428C Backhoe Loader Side Shift, Parallel Lift 2CR00001-16211 (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Side Shift, Single Tilt 1JR00001-01106 (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Side Shift, Parallel Lift 1TR00001-01283 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Single Tilt 4ZN00001-16043 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Single Tilt 5YN00001-15147 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Parallel Lift 1WR00001-08115 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Parallel Lift 1XR00001-02183 (MACHINE) POWERED BY 3054 Engine
416B Backhoe Loader 8SG00001-11999 (MACHINE) POWERED BY 3054 Engine
428C Backhoe Loader Center Pivot, Single Tilt 8RN04089-04989 (MACHINE) POWERED BY 3054 Engine
428C Backhoe Loader Side Shift, Parallel Lift 2CR16212-19309 (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Side Shift, Single Tilt 1JR01107-01149 (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Side Shift, Parallel Lift 1TR01284-01549 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Single Tilt 4ZN16044-50156 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader 1WR08116-10736 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Parallel Lift 1XR02184-02249 (MACHINE) POWERED BY 3054 Engine
416B Backhoe Loader 8SG12000-14798 (MACHINE) POWERED BY 3054 Engine
416C Backhoe Loader Center Pivot, Parallel Lift 1XR02250-02261 (MACHINE) POWERED BY 3054 Engine
428C Backhoe Loader Side Shift, Single Tilt 8RN04990-UP (MACHINE) POWERED BY 3054 Engine
428C Backhoe Loader Side Shift, Parallel Lift 2CR19310-UP (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Center Pivot, Single Tilt 1JR01150-01155 (MACHINE) POWERED BY 3054 Engine
438C Backhoe Loader Side shift, Parallel Lift 1TR01550-02096 (MACHINE) POWERED BY 3054 Engine


Parts link Caterpillar catalog:

7T1099 LINK
216, 216B, 216B3, 226B, 226B3, 228, 236, 236B, 236B3, 242B, 242B3, 246C, 246D, 247, 247B, 247B3, 248, 252B3, 256C, 257B3, 259B3, 262C, 262C2, 262D, 267, 267B, 268B, 272C, 272D, 272D XHP, 277C, 277C2, ...
9R7699 LINK AS
416B, 416C, 426B, 426C, 428B, 428C, 436C, 438C
1613237 LINK AS
428B, 428C, 438C
1219747 LINK AS
416C, 426C, 428C, 436C, 438C
1114331 LINK AS
416C, 420D, 420E, 426C, 428C, 428D, 428E, 430D, 430E, 432D, 432E, 436C, 438C, 438D, 442D, 442E
1114336 LINK AS
416C, 420D, 420E, 426C, 428C, 428D, 428E, 430D, 430E, 432D, 432E, 436C, 438C, 438D, 442D, 442E
1114338 LINK AS
416C, 420D, 420E, 426C, 428C, 428D, 428E, 430D, 430E, 432D, 432E, 436C, 438C, 438D, 442D, 442E
1490251 LINK
416C, 420D, 420E, 424D, 426C, 428C, 430D, 430E, 432D, 432E, 436C, 438C, 442D, 442E
1114339 LINK
416C, 420D, 426C, 428C, 428D, 428E, 430D, 432D, 432E, 436C, 438C, 438D, 442D, 442E
9R6140 LINK
416B, 416C, 416D, 420D, 424D, 426B, 426C, 428, 428D, 430D, 436C, 446B
1539459 LINK
426C, 436C, 438C
1545265 LINK AS
416C, 416D, 420D, 424D, 426C, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D
9R5835 LINK AS
414E, 416, 416B, 416C, 416D, 416E, 420D, 422E, 424B, 424B HD, 424D, 426B, 426C, 428, 428B, 428C, 428D, 430D, 436C, 438C
9R5834 LINK AS
414E, 416, 416B, 416C, 416D, 416E, 420D, 422E, 424B, 424B HD, 424D, 426B, 426C, 428, 428B, 428C, 428D, 430D, 436C, 438C
9R7699 LINK AS
416B, 416C, 426B, 426C, 428B, 428C, 436C, 438C
9R9132 LINK AS
416, 416B, 426B, 428B
1149178 LINK
416B, 428B, 438B
7T1099 LINK
216, 216B, 216B3, 226B, 226B3, 228, 236, 236B, 236B3, 242B, 242B3, 246C, 246D, 247, 247B, 247B3, 248, 252B3, 256C, 257B3, 259B3, 262C, 262C2, 262D, 267, 267B, 268B, 272C, 272D, 272D XHP, 277C, 277C2, ...
9R3754 LINK AS
446, 446B, 446D, 450E, 450F
0551256 LINK-PLAIN
446, 446B, 446D, CP-563, CS-531C, CS-531D, CS-563C, CS-563D, CS-573C, CS-573D, CS-583, CS-583C, CS-583D, CS-663E, CS-683E
8Y4618 LINK AS-WIPER
416, 416B, 426B, 428, 428B, 438B
6V6219 LINK-CONNECTING
120G, 120H, 120H ES, 120H NA, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H, 14H NA, 160H, 160H ES, 160H NA, 163H, 163H NA, 16G, 16H, 16H NA, 416B, 416C, ...
6V6208 LINK-CONNECTING
416B, 426B, 428, 428B, 446B, 517, 527, 611, 613B, 613C, 613C II, 615C, 621E, 623E, 627E, 631E, 633E II, 637D, 637E, 65, 651E, 657E, 65C, 75C, 75D, 814F, 815B, 815F, 816F, 826C, 834B, 836, 85C, 85D, 91...
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.