LINK-TRACK-RH 9W2743 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     FT-1114     Vacuum Cap     1    
5P-0306 Vacuum Transducer     1    
6V-4142 Fitting     1    
5K-5068 Fitting     1    Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g01165944
Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 2 g01177310
Remove belt (1). Refer to Operation and Maintenance Manual, "Belts - Inspect / Adjust / Replace".
Disconnect harness assembly (2), tube assemblies (3), and tube assemblies (4) .
Illustration 3 g01177311
Remove bolts (8), axle oil cooler pump (5), bracket assembly (6), and clutch assembly (7) .
Illustration 4 g01177312
Remove bolt (9) in order to remove clutch drive (10) from clutch assembly (7) .
Illustration 5 g01177313
Remove bolts (11) in order to separate axle oil cooler pump (5), bracket assembly (6), and clutch assembly (7) .