LINK-TRACK PIN END 9W3312 - Caterpillar

1. Remove the plug (1) under the right platform and drain the oil from the filter.2. Remove the seat, armrest and the right side console cover. 3. Disconnect two wires (2) at the sender, disconnect two tube assemblies (3). Remove four bolts and washers (5) and panel (4). 4. Remove two bolts and washers (7) and loosen clamp (6). 5. Install Tooling (A) and a hoist to oil filter (8) and remove the filter from the machine. Install the power train oil filter in the reverse order.Disassemble & Assemble Power Train Oil Filter
Start By:a. remove power train oil filter 1. Remove switch (1), O-ring seal (2), plunger (3), and spring (5) from housing assembly (7).2. Remove plug (6) from the cover assembly.3. Remove five bolts (8) that hold cover assembly (4) to the filter housing assembly.4. Remove plug (9) from the housing assembly. 5. Remove locknut (13), retainer and O-ring seal (10), element (11), stud (14) and two O-ring seals (12) from cover assembly (4).6. Inspect O-ring seal and replace if necessary. Thoroughly clean all of the parts. The following Steps are for assembly of the power train oil filter.7. Install stud (14) into cover assembly (4). Put element (11), retainer and O-ring seal (10), and locknut (13) in position on the stud. Tighten locknut (13) to a torque of 13.6 2.7 N m (122 24 lb in).8. Install two O-ring seals (12) onto cover assembly (4).9. Put cover assembly (4) into position in housing assembly (7) and install five bolts (8).10. Install plug (6) into the cover assembly.11. Install plug (9) into the housing assembly.12. Install spring (5), plunger (3), O-ring seal (2) and switch (1) into housing assembly (7).End By:a. install power train oil filter