LINK AS-TRACK 9W9945 - Caterpillar

table
Illustration 6 g00598971
Typical example
Remove two washers (9) from the front drive housing.
Remove all of the bolts that hold the engine oil pan to the engine. Install 3/8-16 NC guide bolts in both sides of the engine oil pan. Attach a suitable lifting device to the engine and lift the engine off the engine oil pan 12 mm (0.5 inch). Install two 50 mm wide x 100 mm long x 6mm thick (2 inch x 4 inch x 1/4 inch) plates between the engine and the engine oil pan. Rest the engine on the plates.
Illustration 7 g00598973
Typical example
Install Tool (C) and attach a suitable lifting device to front drive housing (10). Remove front drive housing (10) and the gasket. The front drive housing weighs approximately 209 kg (460 lb). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 1P-0520 Driver Group 1
B 138-7573 Link Bracket 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 8 g00599039
Typical example
Install the front drive housing gasket on the cylinder block. Install two 5/8-11 NC guide bolts in the cylinder block.
Install Tool (B) and attach a suitable lifting device to front drive housing (10). Position front drive housing (10) on the guide bolts.
Install the bolts in front drive housing (10) and tighten the bolts evenly. Cut the excess gasket at the face of the cylinder block.
Attach a suitable lifting device to the engine and lift the engine enough to remove the two plates between the engine and the engine oil pan. Install all of the bolts that hold the engine oil pan to the engine.
Inspect the condition of the gasket on the engine oil pan. Replace the gasket, if necessary. Install all of the bolts in the engine oil pan.
Illustration 9 g00598971
Typical example
Install two washers (9) in front drive housing (10).
Illustration 10 g00598970
Typical example
Use Tool (A) to install the bearing in idler gear (7). The bearing must have a diameter of 90.00 0.06 mm (3.543 0.002 inch) after installation.
Place clean engine oil on the O-ring seal of shaft (8). Install idler gear (7) and shaft (8) on both sides of the engine.
Illustration 11 g00598967
Typical example
Place clean engine oil and the O-ring seals and install cover (6).
Illustration 12 g00598966
Typical example
Lubricate the O-ring seals on tube (3) with glycerin. Install tube (3) and elbow (5).
Install four tubes (4).
Illustration 13 g00598964
Typical example
Use a 1/2-13 forged eyebolt and a suitable lifting device to install mounting bracket (2) on the front drive housing. Install the ten bolts.
Illustration 14 g00598961
Typical example
Install four clamps (1). End By:
Install the auxiliary water pump.
Install the engine oil and water pump drive.
Install the accessory drive (front).
Install the crankshaft front seal and the wear sleeve.
Install the engine oil filter housing.