LINKAGE AR-BUCKET 2202502 - Caterpillar

Illustration 1 g06206496
Open the rear access door on the right side of the machine.
Illustration 2 g03803895
Remove hydraulic tank filler cap.
Illustration 3 g03803908
Remove the rear cover plate.
Illustration 4 g03803958
Connect 159-3727 Drain Tube that is stored inside the left access door to the drain valve to drain the hydraulic oil into a suitable container.
Illustration 5 g03803908
Install the rear cover plate .
Change the hydraulic system filters. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Filter - Replace" and “Hydraulic System Oil Filter (Winch) - Replace” (If Equipped).
Fill the hydraulic system oil tank. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" and Operation and Maintenance Manual, "Capacities (Refill)".
Illustration 6 g03803895
Install the hydraulic cap.
Start the engine and run the engine for a few minutes.
Illustration 7 g03803970
Maintain the hydraulic oil level above the "ADD" mark on the sight gauge . Add oil, if necessary.Note: The oil must be free of bubbles. If bubbles are present in the oil, air is entering the hydraulic system. Inspect the suction hoses and the hose clamps.
Stop the engine.
If necessary, tighten any loose clamps and any loose connections. Replace any damaged hoses.