LOCATOR AS 2492937 - Caterpillar

Installation of Cover Plates
Illustration 41 g03751758
View of cover plates that have been installed
(1) Center body assembly
(2) Right-hand body assembly
(8) Cover
(9) Bolt
(10) Washer
Install three covers (8) onto the right-hand body assembly (2).
Use 12 bolts (9) and 12 hard washers (10) to install the covers.Installation of the Canopy Wrapper Plates and Corner Transition Plates
Illustration 42 g03404852
View of theinsidethe body assembly
(1) Center body assembly
(2) Right-hand body assembly
(5) Left-hand body assembly
(11) Plate
(12) Plate
(13) Plate
Weld suitable lifting eyes onto two plates (11). Use a suitable lifting device to place plates (11) in the location that is shown. Plates (11) are located between the canopy and the body assemblies.Note: The approximate weight of one plate (11) is 166 kg (366 lb).
Weld suitable lifting eyes onto plate (12). Use a suitable lifting device to place plate (12) in the location that is shown. Plate (12) is on left-hand body assembly (5) .Note: The approximate weigh of plate (12) is 40 kg (88 lb).
Weld suitable lifting eyes onto plate (13). Use a suitable lifting device to place plate (13) in the location that is shown. Plate (13) is on right-hand body assembly (5) .Note: The approximate weigh of plate (13) is 40 kg (88 lb).
Remove the lifting eyes and grind the welds smooth.
Finish weld two plates (11), plate (12), and plate (13) to the body assembly.Reference: Refer to Special Instruction, SEHS0013, "Body Assembly Procedure" for specific locations, dimensions, and welds required for the installation