LOCK 0L0364 - Caterpillar

E368Conditions Which Generate This Code:The Electronic Control Module (ECM) detects a problem with the engine's intake manifold air temperature. Information on default settings and ranges for this event can be found in Troubleshooting, "Event Codes".System Response:The event code will be logged.Possible Performance Effect:E368-1NoneTroubleshooting:Test Step 1. Perform the following Inspections
Check for Cooling System Problems
Verify that the cooling system is filled to the proper level. If the coolant level is too low, air will get into the cooling system. Air in the cooling system may cause cavitation. This will cause a reduction in coolant flow which can damage a cooling system.
Check the quality of the coolant. Ensure that the coolant meets specifications for the engine.
If equipped, check for adequate coolant flow through the radiator. Check the inlet temperature of the coolant at the radiator inlet. Compare the reading to the regulated temperature. If the temperature is OK, check the outlet temperature of the coolant at the radiator outlet. A high temperature differential indicates an insufficient flow rate.
Check for air in the cooling system. Air can enter the cooling system in different ways. The most common causes of air in the cooling system are the incorrect filling of the cooling system and combustion gas leakage into the cooling system. Combustion gas can get into the system through a cracked cylinder liner, damaged cylinder liner seals, a cracked cylinder head, or a damaged cylinder head gasket.
Check the cooling system hoses and clamps. Damaged hoses with leaks can normally be seen. Hoses that have no visual leaks can soften during operation. The soft areas of the hose can become kinked during operation. These areas can also collapse during operation. These areas of the hose can restrict the coolant flow. Hoses become soft and/or get cracks after a period of time. The inside of a hose can deteriorate, and the loose particles of the hose can restrict the coolant flow.
If a sea water strainer is used in the application, verify that the sea water strainer is not plugged.
Check the heat exchanger for a restriction to the flow of water.
Check the water pump. A water pump with a damaged impeller does not pump enough coolant. Remove the water pump and check for damage to the impeller.
Check the water temperature regulator. A water temperature regulator that does not open, or a water temperature regulator that only opens part of the way can cause overheating.
If the cooling system is equipped with an expansion tank, check the shunt line for the expansion tank. The shunt line must remain submerged in the coolant for proper operation. A restriction of the shunt line from the expansion tank to the inlet of the jacket water pump will cause a reduction in water pump efficiency. A reduction in water pump efficiency will result in low coolant flow.
If the cooling system is equipped with an aftercooler, check the aftercooler. A restriction of air flow through the air to air aftercooler can cause overheating of the engine. Check for debris or deposits which would