LOCK GP-VANDALISM 9W6442 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 3R-1937 Barring Gp(1) 1
(1) The 285-5989 Engine Turning Tool is alternate tooling.Start By:
Remove the piston cooling jets.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Use Tooling (A) to turn the flywheel in order to access the connecting rod cap that will be removed.
Illustration 1 g01064418Note: Inspect the connecting rod and connecting rod cap for the proper identification mark. The connecting rod and the connecting rod cap should have an etched number on the side. The number should match the cylinder number. Mark the connecting rod and the connecting rod cap, if necessary.
Remove bolts (1) and connecting rod cap (2) from the crankshaft.
Push the connecting rod away from the crankshaft and remove the upper half of the connecting rod bearing.
Illustration 2 g01064420
Remove lower half (3) of the connecting rod bearing from connecting rod cap (2). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
B 334-0519 Grease 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Check the clearance of the bearings.
Place clean engine oil on the connecting rod bearings.
Illustration 3 g01064420
Install lower half (3) of the connecting rod bearing in connecting rod cap (2). Ensure that the tab on the back of the bearing is in the bearing tab groove on the connecting rod cap.
Install the upper half of the connecting rod bearing in the connecting rod. Ensure that the tab on the back of the bearing is in the bearing tab groove on the connecting rod.
Position the connecting rod on the crankshaft.
Illustration 4 g01064418
Position connecting rod cap (2) onto the connecting rod. Ensure that the number on the side of connecting rod cap (2) corresponds to the number that is on the connecting rod.
Apply Tooling (B) to bolts (1) and install bolts (1).
Illustration 5 g01064455
(4) Side of the connecting rod with the chamfer
(5) Location pin
Tighten Bolts (A) and (B) to 90 5 N m (65 4 lb ft).
Tighten Bolts (C) and (D) to 90 5 N m (65 4 lb ft).
Tighten Bolts (C) and (D) again to 90 5 N m (65 4 lb ft).
Tighten all of the bolts for an additional 90 5 degrees (1/4 turn).
Check the side clearance that is between two of the connecting rods that are on the same journal. The clearance must be 0.85 0.332 mm (0.034 0.0130 inch). End By:
Install the piston cooling jets.