LOCKNUT-BEARING 4H7859 - Caterpillar

Three60 Precision Control Group (if equipped)
Illustration 1 g03803152
Three60 precision control home screen
Tap the "Three60 PC" soft button on the direct-access screen to access the Three60 precision control home screen. The home screen is shown in Illustration 1.Note: The direct-access screen will appear when you hold "Home" button for 2 seconds.
Illustration 2 g03803156
Installation with "Three60 Hold"
(1) Three60 Hold soft key for "Three60 Hold"If the vessel is equipped with "Three60 Hold", a "Three60 Hold" soft button in the lower left corner of the screen will be displayed. Refer to Illustration 2.
Illustration 3 g03803158
Starboard engine details
Swipe left to display the starboard engine details screen as shown in Illustration 3.
Illustration 4 g03803176
Port engine details
Swipe left again to display the port engine details as shown in Illustration 4.Three60 Hold Active
Illustration 5 g03803200
"Three60 Hold" home screen
(1) Three60 Hold soft key for "Three60 Hold"To activate "Three60 Hold", press or swipe the "Three60 Hold" soft key (1) on the Three60 home screen. If all criteria for "Three60 Hold" are met, the acknowledgment screen will appear. Refer to Illustration 6.Note: "Three60 Hold" can only be activated from the display that is located on the bridge.
Illustration 6 g03803197
"Three60 Hold" acknowledgment dialog
The vessel is underway with propellers spinning and may move suddenly without warning. Being in the water near the vessel may result in personal injury.Read the Operation and Maintenance Manual for safe use of the system. Stay out of the water while the vessel is underway and hold on to prevent falling into the water. Always be aware of your surroundings.
Read the caution shown above. After reading the caution message, use the following instructions to change to "Three60 Hold" mode.
Tap the "ACCEPT" soft button, as shown in Illustration 6, to transition to "Three60 Hold".
Tap the "CANCEL" soft button, shown in Illustration 6, to return to the previously displayed screen.Note: If "ACCEPT" is tapped, the GPS position of the vessel is stored as the "Hold Position". The "Three60 Hold" home screen shown in Illustration 5 will appear.
Illustration 7 g03803216
Vessel drift present in "Three60 Hold" mode
(2) Port side propeller shaft speed
(3) Starboard side propeller shaft speed
(4) Status of the bow thruster
(5) Status of the stern thruster
(6) Three60 Hold statusRefer to Illustration 7. The port (2) and starboard (3) propeller shaft speeds are shown in the upper left and upper right of the screen. The status of the bow thruster (4) and the stern thruster (5) are shown in the lower right of the screen. The "Three60 Hold" status (6) is shown in the lower left.In the center of the screen is a display of the location vessel with respect to the "Hold" position. Upon entering "Three60 Hold", the vessel icon is centered on the screen and is shown in green. If the vessel drifts off the Hold position, the vessel icon will move from the center, in the direction of the drift. The three circles indicate how much the vessel has drifted.If the vessel drifts more than 6 m (20 ft) from the "Hold" location, the vessel icon will be in the second circle. The vessel icon