LOCKWASHER 4762814 - Caterpillar

Image1.5.1
4. Route the battery cable (+) by removing the three clip points on the frame and clipping along the existing harness mounts. Using the existing hardware, fasten the battery cable (+) to the lower clipping point. Using two 8T-8136 bolts, fasten the battery cable (+) to the upper two clipping points near the existing harness clips.
Image1.6.1
5. Connect the battery cable (+) to the starter and fasten using the existing hardware. Rotate the dovetail clip to better orient it with the wire harness.
Image1.7.1
6. Fasten the ground cable (-) to the engine block the same as it was on the existing starter.
Image1.8.1
7. Route and fasten the second ground cable (-) to the right hand frame using the existing hardware and clipping points.
Image1.9.1
REWORK ITEM #32: C9.3 Non-Vented Thermostat
For instructions, refer to REBE8071, "Product Improvement Program for Replacing the NRS Venturi and Engine Thermostat on Certain D6T and D7E Track-Type Tractors - Multiple Repairs". Please refer to steps 1 and 2 of Thermostat Replacement.
Image1.10.1