LUG-CLEVIS 5378517 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Sometimes upon start-up, a CD700 display with version 10.80 software will not find any devices on the CAN bus. When this error occurs, the message "Some of the Required System Devices are Not Responding" will appear on the screen. If you reboot the display, all of the devices that are on the CAN bus are usually found.Solution
Upgrade the 244-1716 Monitor Display Gp . Obtain the files by submitting a ticket to the Dealer Solution Network (DSN). Place the name "New OS Needed for AccuGrade v10.8" on the title of the ticket. The ".bin" files will be attached to the ticket.In order to upgrade the display, use the "Display Firmware Upgrade" section in the following manuals:
Systems Operation, Testing and Adjusting, KENR5965, "AccuGrade® - CD700 Grade Control System (GPS/ATS/Laser)"
Systems Operation, Testing and Adjusting, KENR6319, "AccuGrade® CD700 Grade Control System (GPS/ATS/Laser/Cross Slope/Sonic)"
Systems Operation, Testing and Adjusting, RENR9533, "AccuGrade® GPS (CD700)"
Systems Operation, Testing and Adjusting, KENR5957, "AccuGrade® Compaction GPS Mapping and Measurement System"
Systems Operation, Testing and Adjusting, KENR5956, ""Note: These files have the same names as the operating files that were distributed with version 10.80. The new files contain updates to the version 10.80 software. The following files are included in the upgrade: "eboot.bin", "fpga_cmb.bin" and "nk.bin". No ".SG2" files are used for this upgrade.