LUG 9J3344 - Caterpillar

Clean and lubricate all threads with 4C-5593 Thread Lubricant or similar lubricant to the following bolts prior to assembly.(1) Torque for eight bolts that fasten retainer to housing ... 50 7 N m (37 5 lb ft)(2) Torque for six bolts that fasten retainer to housing ... 50 7 N m (37 5 lb ft)(7) Torque for six bolts that fasten retainer to housing ... 50 7 N m (37 5 lb ft)(10) Thickness of 9EL2151 shim pack 2.03 mm (.080 in) Add shims as needed to get correct end play of gear (8) of ... 0.15 0.05 mm (.006 .002 in)(11) Torque for six bolts that fasten retainer to housing ... 50 7 N m (37 5 lb ft) Clean bolt threads with Locquic Primer and apply Loctite 271 or similar thread lock prior to assembly.(16) Torque for bolt that fastens yoke to shaft ... 135 15 N m (100 11 lb ft) Clean and lubricate all threads with 4C-5593 Thread Lubricant or similar lubricant to the following bolts prior to assembly.(18) Torque for six bolts that fasten retainer to housing ... 50 7 N m (37 5 lb ft)(19) Thickness of 9EL2077 shim pack ... 2.03 mm (.080 in) Add shims as needed to get correct end play of gear (3) of ... 0.15 0.05 mm (.006 .002 in)(26) Thickness of 6P-7767 shim pack ... 2.00 mm (.079 in) Add shims as needed to get correct end play of gear (2) of ... 0.15 0.05 mm (.006 .002 in)(29) Torque for twelve bolts that fasten adapter to housing ... 50 7 N m (37 5 lb ft) Clean bolt threads with Locquic Primer and apply Loctite 271 or similar thread lock prior to assembly.(30) Torque for bolt that fastens idler shaft/gear assembly to housing ... 120 20 N m (90 15 lb ft) Clean and lubricate all threads with 4C-5593 Thread Lubricant or similar lubricant to the following bolts prior to assembly.(31) Torque for twelve bolts that fasten retainer to housing ... 50 7 N m (37 5 lb ft)(32) Torque for six bolts that fasten retainer to housing ... 50 7 N m (37 5 lb ft)(33) Torque for eight bolts that fasten carrier assembly to housing assembly ... 120 20 N m (90 15 lb ft)(34) Torque for 22 bolts that fasten converter housing to flywheel housing ... 74 8 N m (55 6 lb ft) Procedure for Obtaining Correct Gear End Play:1. Place the torque converter and updrive assembly on two even blocks with the output shaft end upright.2. Install retaining ring (9) in groove in gear (8)3. Install gear (8) on the torque converter output shaft. Install the full 9EL2151 shim pack (10) and bearing retainer (13). Do not install the O-ring seals on the retainer. Install bolts (11) that fasten