492-7300 GENERATOR AR S/N G1F1-UP 60-HERTZ. LOW VOLTAGE G3512 GENERATOR SET

492-7300 GENERATOR AR
S/N G1F1-UP
60-HERTZ. LOW VOLTAGE

i06602040 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Part No	Qty	Parts name
492-7301 Y	[1]	GENERATOR GP
228-4798	[1]	FILM-IDENTIFICATION (GROUND)
		INSTALL NEAR GENERATOR GROUND BOLT OR GENERATOR GROUND CUSTOMER CONNECTION POINT.
303-3433	[1]	FILM-IDENTIFICATION (CATERPILLAR)
		INSTALL FILM ON THE REAR PANEL OF THE GENERATOR TERMINAL BOX, CENTERED APPROX. 30MM FROM THE TOP EDGE OF THE LOWER TERMINAL BOX COVER.
303-3440	[2]	FILM-IDENTIFICATION (CAT)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, AT THE TOP LH CORNER OF THE LOWER TERMINAL BOX COVER, ALIGN EACH FILM WITH THE EDGES OF THE COVER.
		IF THERE IS A CIRCUIT BREAKER, MOVE FILM TO THE BOTTOM OF THE COVER, BELOW THE CIRCUIT BREAKER, ALIGN FILM WITH THE EDGES OF THE COVER.
7W-5893	[4]	FILM-INFORMATION (GENERATOR LIFTING)
		INSTALL ONE DIRECTLY ABOVE EACH LIFTING HOLE ON GENERATOR BARREL.
118-8452	[1]	FILM-INFORMATION (GENERATOR)
		INSTALL FILM ON THE RH SIDE OF THE GENERATOR BARREL, CENTERED FROM FRONT TO BACK, APPROX. 100MN DOWN FROM THE CENTER LINE AT THE TOP OF THE GENERATOR.
		INSTALL FILM ON THE BARREL COVER IF AVAILABLE.
		INSTALL CLEAR LAMINATE OVER FILM.
225-3224	[3]	FILM-WARNING (AUTOMATIC ENGINE START)
		INSTALL ONE FILM ON THE REAR OF THE GENERATOR TERMINAL BOX DIRECTLY BELOW THE ELECTROCUTION HAZARD FILM, AND ONE FILM ON THE RH AND LH SIDES OF THE TERMINAL BOX, CENTERED ABOVE THE CRUSH WARNING. IF THE GENERATOR IS EQUIPPED WITH CIRCUIT BREAKER ON EITHER SIDE, MOVE FILM ABOVE THE BREAKER COVER DIRECTLY BELOW THE 229-5047 FILM.
225-3227	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON EACH SIDE OF THE GENERATOR BARREL, DIRECTLY ON THE GENERATOR BARREL, NOT ON THE BARREL COVER. IF THERE IS NO BARREL COVER, CENTER FILMS ON EACH SIDE THE BARREL FROM FRONT TO REAR, AND ON THE RH SIDE, CENTER FILM BELOW THE 118-8452 GLPS GENERATOR INFO FILM.
229-5047	[3]	FILM-WARNING (SHOCK HAZARD, READ OMM)
		INSTALL ONE FILM ON THE REAR OF THE GENERATOR TERMINAL BOX, CENTERED AT THE TOP OF THE TERMINAL BOX BELOW THE CATERPILLAR DECAL, AND ONE FILM ON THE RH AND LH SIDES OF TERMINAL BOX CENTERED ABOVE THE AUTO START WARNING. IF THE GENERATOR IS EQUIPPED WITH A CIRCUIT BREAKER ON EITHER SIDE, MOVE FILM ABOVE THE BREAKER COVER CENTERED AT THE TOP EDGE OF THE TERMINAL BOX COVER.
Y		SEPARATE ILLUSTRATION

#M00686280611

526-5104: GENERATOR AR

526-5104 GENERATOR AR
S/N G1H1-UP
50/60-HERTZ. 1500/1800-RPM

i07329870 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Pos.	Part No	Qty	Parts name	Comments
1.	Y	[1]	GENERATOR GP
	Y		SEPARATE ILLUSTRATION

#M00686280612

526-5106: GENERATOR AR

526-5106 GENERATOR AR
S/N G1H1-UP
50/60-HERTZ. 1500/1800-RPM

i07330168 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Pos.	Part No	Qty	Parts name	Comments
1.	Y	[1]	GENERATOR GP
	Y		SEPARATE ILLUSTRATION

#M00686280613

553-3944: GENERATOR AR

553-3944 GENERATOR AR
S/N E2P1-UP; E2X1-UP
60/50-HERTZ. 480-VOLT
AN ATTACHMENT

i07331513 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Part No	Qty	Parts name
553-3943 Y	[1]	GENERATOR GP

228-4798	[2]	FILM-IDENTIFICATION (GROUND)
		INSTALL NEAR GENERATOR GROUND BOLT OR GENERATOR GROUND CUSTOMER CONNECTION POINT. USE AS REQUIRED.
303-3428	[1]	FILM-IDENTIFICATION (CAT)
		INSTALL FILM ON THE REAR PANEL OF THE GENERATOR TERMINAL BOX, CENTERED AT THE TOP OF THE TOP OF THE REAR PANEL.
303-3440	[2]	FILM-IDENTIFICATION (CAT)
		INSTALL ONE FILM ON THE RH & LH SIDE OF THE GENERATOR TERMINAL BOX, AT THE TOP LH CORNER OF THE LOWER TERMINAL BOX COVER, ALIGN EACH FILM WITH THE EDGES OF THE COVER. IF THERE IS A CIRCUIT BREAKER MOVE FILM TO THE BOTTOM OF THE COVER, BELOW THE CIRCUIT BREAKER, ALIGN FILM WITH THE EDGES OF THE COVER.
118-8452	[1]	FILM-INFORMATION (GENERATOR)
		INSTALL FILM ON THE RH SIDE OF THE GENERATOR BARREL, CENTERED FROM FRONT TO BACK, APPROX. 100MM DOWN FROM THE CENTER LINE AT THE TOP OF THE GENERATOR. (INSTALL FILM ON THE BARREL COVER IF AVAILABLE.) INSTALL CLEAR LAMINATE OVER FILM.
225-3224	[2]	FILM-WARNING (AUTOMATIC ENGINE START)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED DIRECTLY BELOW THE SHOCK WARNING LABEL.
225-3227	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON EACH SIDE OF THE GENERATOR BARREL, DIRECTLY ON THE GENERATOR BARREL, NOT ON THE BARREL COVER. IF THERE IS NO BARREL COVER, CENTER FILMS ON EACH SIDE THE BARREL FROM FRONT TO REAR, AND ON THE RH SIDE, CENTER FILM BELOW THE 118-8452 GLPS GENERATOR INFO FILM.
229-5047	[2]	FILM-WARNING (SHOCK HAZARD, READ OMM)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED DIRECTLY BELOW THE CAT POWER EDGE LABEL.
Y		SEPARATE ILLUSTRATION

#M00686280614

553-3948: GENERATOR AR

553-3948 GENERATOR AR
S/N G1B1-UP
60/50-HERTZ. 480-VOLT

i07322554 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Part No	Qty	Parts name
553-3947 Y	[1]	GENERATOR GP

228-4798	[2]	FILM-IDENTIFICATION (GROUND)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED DIRECTLY BELOW THE SHOCK WARNING LABEL.
303-3428 Y	[1]	FILM-IDENTIFICATION (CAT)
		INSTALL FILM ON THE REAR PANEL OF THE GENERATOR TERMINAL BOX, CENTERED AT THE TOP OF THE TOP OF THE REAR PANEL.
303-3440	[2]	FILM-IDENTIFICATION (CAT)
		INSTALL ONE FILM ON THE RH & LH SIDE OF THE GENERATOR TERMINAL BOX, AT THE TOP LH CORNER OF THE TERMINAL BOX, ALIGN EACH FILM WITH THE EDGES OF THE TERMINAL BOX COVER.
118-8452	[1]	FILM-INFORMATION (GENERATOR)
		INSTALL FILM ON THE RH SIDE OF THE GENERATOR BARREL, CENTERED FROM FRONT TO BACK, APPROX. 100MM DOWN FROM THE CENTER LINE AT THE TOP OF THE GENERATOR.(INSTALL FILM ON THE BARREL COVER IF AVAILABLE.) INSTALL CLEAR LAMINATE OVER FILM.
225-3224	[2]	FILM-WARNING (AUTOMATIC ENGINE START)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED DIRECTLY BELOW THE SHOCK WARNING LABEL.
225-3227	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON EACH SIDE OF THE GENERATOR BARREL, DIRECTLY ON THE GENERATOR BARREL, NOT ON THE BARREL COVER. IF THERE IS NO BARREL COVER, CENTER FILMS ON EACH SIDE OF THE BARREL FROM FRONT TO REAR, AND ON THE RH SIDE, CENTER FILM BELOW THE 118-8452 GLPS GENERATOR INFO FILM.
229-5047	[2]	FILM-WARNING (SHOCK HAZARD, READ OMM)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED DIRECTLY BELOW THE CAT POWER EDGE LABEL.
Y		SEPARATE ILLUSTRATION

#M00686280615

252-3755: GENERATOR GP

252-3755 GENERATOR GP
S/N G1B1-UP
50/60-HERTZ. 480-VOLT. 1402-FRAME, 4-POLE, 6-LEAD
PART OF 252-3756 GENERATOR AR

i02593305 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Pos.	Part No	Qty	Parts name
1.	253-9769 Y	[1]	BRACKET GP-MOUNTING (OPPOSITE DRIVE END)
2.	253-9995 Y	[1]	BRACKET GP-MOUNTING (DRIVE END)
3.	254-0002 Y	[1]	COUPLING GP
4.	253-9799 Y	[1]	EXCITER GP (POWER)
5.	253-9781 Y	[1]	MOUNTING GP-GENERATOR
6.	254-8677 Y	[1]	ROTOR GP-GENERATOR
7.	254-0005 Y	[1]	SCREEN GP-AIR
8.	254-8355 Y	[1]	STATOR GP-MAIN
	Y		SEPARATE ILLUSTRATION

#M00686280616

252-3757: GENERATOR GP

252-3757 GENERATOR GP
S/N G1B1-UP
50/60-HERTZ. 480-VOLT. 1402-FRAME, 4-POLE, 6-LEAD
PART OF 252-3758 GENERATOR AR

i02485450 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Pos.	Part No	Qty	Parts name
1.	253-9769 Y	[1]	BRACKET GP-MOUNTING (OPPOSITE DRIVE END)
2.	253-9995 Y	[1]	BRACKET GP-MOUNTING (DRIVE END)
3.	254-0002 Y	[1]	COUPLING GP
4.	253-9799 Y	[1]	EXCITER GP (POWER)
5.	253-9781 Y	[1]	MOUNTING GP-GENERATOR
6.	254-8677 Y	[1]	ROTOR GP-GENERATOR
7.	254-0005 Y	[1]	SCREEN GP-AIR
8.	254-8356 Y	[1]	STATOR GP-MAIN
9.	249-7649 Y	[1]	CONNECTOR AS (RESISTIVE TEMPERATURE DEVICE)
	Y		SEPARATE ILLUSTRATION

#M00686280617

252-3759: GENERATOR GP

252-3759 GENERATOR GP
S/N G1B1-UP
50/60-HERTZ. 480-VOLT. 1402-FRAME, 6-LEAD, 4-POLE
PART OF 252-3760 GENERATOR AR

i02485452 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Pos.	Part No	Qty	Parts name
1.	253-9769 Y	[1]	BRACKET GP-MOUNTING (OPPOSITE DRIVE END)
2.	253-9995 Y	[1]	BRACKET GP-MOUNTING (DRIVE END)
3.	254-0002 Y	[1]	COUPLING GP
4.	253-9799 Y	[1]	EXCITER GP (POWER)
5.	253-9814 Y	[1]	EXCITER GP (PERMANENT MAGNET)
6.	253-9781 Y	[1]	MOUNTING GP-GENERATOR
7.	254-8677 Y	[1]	ROTOR GP-GENERATOR
8.	254-0005 Y	[1]	SCREEN GP-AIR
9.	254-8357	[1]	STATOR GP-MAIN
	8T-4189 M	[3]	BOLT (M8X1.25X20-MM)
	M		METRIC PART
	Y		SEPARATE ILLUSTRATION

#M00686280618

252-3761: GENERATOR GP

252-3761 GENERATOR GP
S/N G1B1-UP
50/60-HERTZ. 480-VOLT. 1402-FRAME, 6-LEAD, 4-POLE
PART OF 252-3762 GENERATOR AR

i02485454 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET:

Pos.	Part No	Qty	Parts name
1.	253-9769 Y	[1]	BRACKET GP-MOUNTING (OPPOSITE DRIVE END)
2.	253-9995 Y	[1]	BRACKET GP-MOUNTING (DRIVE END)
3.	254-0002 Y	[1]	COUPLING GP
4.	253-9799 Y	[1]	EXCITER GP (POWER)
5.	253-9814 Y	[1]	EXCITER GP (PERMANENT MAGNET)
6.	253-9781 Y	[1]	MOUNTING GP-GENERATOR
7.	254-8677 Y	[1]	ROTOR GP-GENERATOR
8.	254-0005 Y	[1]	SCREEN GP-AIR
9.	254-8358 Y	[1]	STATOR GP-MAIN
10.	249-7649 Y	[1]	CONNECTOR AS (RESISTIVE TEMPERATURE DEVICE)
	Y		SEPARATE ILLUSTRATION

#M00686280619

252-3771: GENERATOR GP

252-3771 GENERATOR GP
S/N G1F1-UP
50/60-HERTZ. 480-VOLT. 1424-FRAME, 6-LEAD, 4-POLE
PART OF 252-3772 GENERATOR AR

i02485456 M0068628

For full view, you need register

Parts for your G3512 GENERATOR SET: