ELECTRICAL AND STARTING SYSTEM
SENSOR GPSTARTING AID GP
STARTING AR
STARTING MOTOR GP
SWITCH GP
ELECTRICAL AND STARTING SYSTEM
SENSOR GP
#M00726300280
454-5075: SENSOR GP-PRESSURE
454-5075 SENSOR GP-PRESSURE
S/N JFR10001-UP; HBT10001-UP
PART OF 486-7382 LINES GP-FRONT, 484-6965, 484-6975 LINES GP-PILOT, 484-6970 SENSOR GP-PRESSURE
S/N JFR10001-UP; HBT10001-UP
PART OF 486-7382 LINES GP-FRONT, 484-6965, 484-6975 LINES GP-PILOT, 484-6970 SENSOR GP-PRESSURE
For full view, you need register
#M00726300281
484-6970: SENSOR GP-PRESSURE
484-6970 SENSOR GP-PRESSURE
S/N JFR1-UP; HBT1-UP
PART OF 497-3877, 512-6082 CONTROL AR-AUXILIARY
S/N JFR1-UP; HBT1-UP
PART OF 497-3877, 512-6082 CONTROL AR-AUXILIARY
For full view, you need register
#M00726300282
390-2776: SENSOR GP-SOOT
For full view, you need register
#M00726300283
383-8589: SENSOR GP-TEMPERATURE
For full view, you need register
#M00726300284
383-8600: SENSOR GP-TEMPERATURE
For full view, you need register
#M00726300285
324-4528: STARTING AID GP-ETHER
324-4528 STARTING AID GP-ETHER
S/N JFR1-UP; HBT1-UP
PART OF 342-4250 STARTING AR-COLD WEATHER
S/N JFR1-UP; HBT1-UP
PART OF 342-4250 STARTING AR-COLD WEATHER
For full view, you need register
Parts for your 330F EXCAVATOR:
| Pos. | Part No | Qty | Parts name | Comments |
|---|---|---|---|---|
| 1. | 204-1611 | [1] | STRAP (DUAL) | |
| 2. | 239-1134 Y | [1] | VALVE GP-ETHER STARTING (24-VOLT) | |
| 3. | 241-4194 | [1] | FITTING AS (CONTROL) | |
| 236-4545 | [1] | NUT-SLEEVE (5/16-24-THD) | ||
| 4. | 247-3774 | [1] | ATOMIZER AS (ETHER) | |
| 236-4545 | [1] | NUT-SLEEVE (5/16-24-THD) | ||
| 5. | 339-6891 | [4] | STRAP-CABLE | |
| 6. | 339-7043 | [1] | SUPPORT | |
| 7. | 8T-4192 M | [2] | BOLT (M12X1.75X25-MM) | |
| 8. | 8T-4200 M | [2] | BOLT (M8X1.25X16-MM) | |
| 9. | 8T-4223 | [2] | WASHER-HARD (13.5X25.5X3-MM THK) | |
| 10. | 8T-4224 | [2] | WASHER-HARD (8.8X16X2-MM THK) | |
| 11. | 174-9169 E | TUBE (109-CM) | ||
| 7N-0296 A | [1] | CYLINDER AS-ETHER | ||
| (MUST BE PROCURED LOCALLY FROM YOUR CAT DEALER) | ||||
| A | NOT PART OF THIS GROUP | |||
| E | ORDER BY THE CENTIMETER | |||
| M | METRIC PART | |||
| Y | SEPARATE ILLUSTRATION | |||
#M00726300286
342-4250: STARTING AR-COLD WEATHER
342-4250 STARTING AR-COLD WEATHER
S/N JFR1-UP; HBT1-UP
PART OF 506-5133, 506-5136, 526-3318, 551-2704 DISTRIBUTION AR
S/N JFR1-UP; HBT1-UP
PART OF 506-5133, 506-5136, 526-3318, 551-2704 DISTRIBUTION AR
For full view, you need register
#M00726300287
354-5671: STARTING MOTOR GP-ELECTRIC
354-5671 STARTING MOTOR GP-ELECTRIC
S/N D8T1-UP
PART OF 391-2934 STARTING MOTOR GP-ELECTRIC
S/N D8T1-UP
PART OF 391-2934 STARTING MOTOR GP-ELECTRIC
For full view, you need register
Parts for your 330F EXCAVATOR:
| Pos. | Part No | Qty | Parts name | Comments |
|---|---|---|---|---|
| 1. | 230-4012 | [1] | RECEPTACLE AS-CONNECTOR (2-PIN) | |
| 2. | 488-3767 | [1] | YOKE AS | |
| 3. | 488-3768 | [1] | HOLDER AS-BRUSH | |
| 4. | 488-3770 | [1] | ARMATURE AS | |
| 5. | 488-3771 | [1] | DRIVE AS-CLUTCH | |
| 6. | 488-3779 | [1] | HOUSING AS-DRIVE | |
| 7. | 488-3787 | [1] | SWITCH AS-RELAY | |
| AVAILABLE REPAIR KIT(S): | ||||
| 488-3794 | [1] | KIT-GEAR | ||
| (KIT INCLUDES: SHOCK ABSORBER AND GEAR) | ||||
| 488-3797 | [1] | KIT-SHIFT LEVER | ||
| (KIT INCLUDES: SHAFT, LEVER, AND WASHERS) | ||||
| 488-3798 | [1] | KIT-PINION | ||
| (KIT INCLUDES: NUTS, PINION,RETAINER, AND SPR) | ||||
| 488-3799 | [1] | KIT-HARDWARE | ||
| (KIT INCLUDES: BOLTS, NUTS, SCREWS, AND WASHERS) | ||||
#M00726300288
391-2934: STARTING MOTOR GP-ELECTRIC
391-2934 STARTING MOTOR GP-ELECTRIC
S/N D8T1-UP
PART OF 390-3705 ENGINE AR-PRIMARY
S/N D8T1-UP
PART OF 390-3705 ENGINE AR-PRIMARY
For full view, you need register
#M00726300289
7N-0719: SWITCH GP-DISCONNECT
7N-0719 SWITCH GP-DISCONNECT -BATTERY
S/N JFR1-UP; HBT1-UP
PART OF 388-6826, 494-8496 BATTERY & WIRING GP
S/N JFR1-UP; HBT1-UP
PART OF 388-6826, 494-8496 BATTERY & WIRING GP
For full view, you need register
Information:
ELECTRICAL AND STARTING SYSTEM
SENSOR GP
Disassembly and Assembly
Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C7.1 Engines for Caterpillar Built Machines
C7.1 Engines for Caterpillar Built Machines
Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Differential Pressure Sensor and Absolute Pressure Sensor
C7.1 Engines for Caterpillar Built Machines
C7.1 Engines for Caterpillar Built Machines
Temperature Sensor (DPF) - Remove and Install - Inlet and Outlet Temperature Sensors (DPF)
C7.1 Engines for Caterpillar Built Machines
C7.1 Engines for Caterpillar Built Machines
Nitrogen Oxide Sensor - Remove and Install - Nitrogen Oxide Sensor for Clean Emissions Module (CEM)
C7.1 Engines for Caterpillar Built Machines
C7.1 Engines for Caterpillar Built Machines
Nitrogen Oxide Sensor - Remove and Install - Original Equipment Manufacturer (OEM) Exhaust Pipe
C7.1 Engines for Caterpillar Built Machines
C7.1 Engines for Caterpillar Built Machines
Turbocharger Exhaust Temperature Sensor - Remove and Install
C7.1 Engines for Caterpillar Built Machines
C7.1 Engines for Caterpillar Built Machines
