463-0156 GENERATOR AR S/N TZK1-UP; G1N1-UP; FLX1-UP 50/60-HERTZ. LOW VOLTAGE ALSO AN ATTACHMENT C32 GENERATOR SET

Part No	Qty	Parts name
463-0157 Y	[1]	GENERATOR GP
228-4798	[1]	FILM-IDENTIFICATION (GROUND)
		INSTALL NEAR GENERATOR GROUND BOLT OR GENERATOR GROUND CUSTOMER CONNECTION POINT.
303-3433	[1]	FILM-IDENTIFICATION (CATERPILLAR)
		INSTALL FILM ON THE REAR PANEL OF THE GENERATOR TERMINAL BOX,
		CENTERED APPROX. 30MM FROM THE TOP EDGE OF THE LOWER TERMINAL BOX COVER.
303-3440	[2]	FILM-IDENTIFICATION (CAT)
		INSTALL ONE FILM ON THE RH & LH SIDE OF THE GENERATOR TERMINAL BOX, AT THE TOP LH CORNER OF THE TERMINAL BOX,
		ALIGN EACH FILM WITH THE EDGES OF THE TERMINAL BOX COVER.
		IF THERE IS A CIRCUIT BREAKER, MOVE FILM TO THE BOTTOM OF THE COVER, BELOW THE CIRCUIT BREAKER.
		ALIGN FILM WITH THE EDGES OF THE COVER.
118-8452	[1]	FILM-INFORMATION (GENERATOR)
		INSTALL FILM ON THE RH SIDE OF THE GENERATOR BARREL, CENTERED FROM FRONT TO BACK,
		APPROX. 100MM DOWN FROM THE CENTER LINE AT THE TOP OF THE GENERATOR.
		INSTALL CLEAR LAMINATE OVER FILM.
7W-5893	[4]	FILM-INFORMATION (GENERATOR LIFTING)
		INSTALL ONE DIRECTLY ABOVE EACH LIFTING HOLDE ON GENERATOR BARREL.
225-3224	[3]	FILM-WARNING (AUTOMATIC ENGINE START)
		INSTALL ONE FILM ON THE REAR OF GENERATOR TERMINAL BOX, DIRECTLY BELOW THE ELECTROCUTION HAZARD FILM
		AND ONE FILM ON THE RH & LH SIDES OF THE TERMINAL BOX, CENTERED ABOVE THE CRUSH WARNING,
		IF THE GENERATOR IS EQUIPPED WITH CIRCUIT BREAKER ON EITHER SIDE,
		MOVE FILM ABOVE THE BREAKER COVER DIRECTLY BELOW THE 229-5047 FILM.
225-3227	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON EACH SIDE OF THE GENERATOR BARREL, DIRECTLY ON THE GENERATOR BARREL, NOT ON THE BARREL COVER.
		IF THERE IS NO BARREL COVER, CENTER FILMS ON EACH SIDE OF THE BARREL FROM FRONT TO REAR,
		AND ON THE RH SIDE, CENTER FILM BELOW THE 118-8452 GLPS GENERATOR INFO FILM.
229-5047	[3]	FILM-WARNING (SHOCK HAZARD, READ OMM)
		INSTALL ONE FILM ON THE REAR OF THE GENERATOR TERMINAL BOX,
		CENTERED AT THE TOP OF THE TERMINAL BOX BELOW THE CATERPILLAR DECAL,
		AND ONE FILM ON THE RH & LH SIDE OF TERMINAL BOX CENTERED ABOVE THE AUTO START WARNING.
		IF THE GENERATOR IS EQUIPPED WITH A CIRCUIT BREAKER ON EITHER SIDE,
		MOVE FILM ABOVE THE BREAKER COVER CENTERED AT THE TOP EDGE OF THE TERMINAL BOX COVER.
Y		SEPARATE ILLUSTRATION

#M00770020862

463-0160: GENERATOR AR

GENERATOR AR

463-0160 GENERATOR AR
S/N TZK1-UP; G1N1-UP; FLX1-UP
50/60-HERTZ. LOW VOLTAGE
ALSO AN ATTACHMENT

i05979260 M0077002

For full view, you need register

Parts for your C32 GENERATOR SET:

CATERPILLAR SIS

Pos.	Part No	Qty	Parts name	Comments
	463-0159 Y	[1]	GENERATOR GP
	Y		SEPARATE ILLUSTRATION

#M00770020863

463-0162: GENERATOR AR

GENERATOR AR

463-0162 GENERATOR AR
S/N G1B1-UP; TZK1-UP; FLX1-UP
50/60-HERTZ. LOW VOLTAGE
ALSO AN ATTACHMENT

i05979278 M0077002

For full view, you need register

Parts for your C32 GENERATOR SET:

CATERPILLAR SIS

Part No	Qty	Parts name
463-0161 Y	[1]	GENERATOR GP
228-4798	[1]	FILM-IDENTIFICATION (GROUND)
		INSTALL NEAR GENERATOR GROUND BOLT OR GENERATOR GROUND CUSTOMER CONNECTION POINT.
303-3433	[1]	FILM-IDENTIFICATION (CATERPILLAR)
		INSTALL FILM ON THE REAR PANEL OF THE GENERATOR TERMINAL BOX, CENTERED APPROX. 30MM FROM THE TOP OF THE REAR PANEL, IF THERE IS AN AIR CLEANER INSTALLED, MOVE FILM BELOW AIR CLEANER CENTERED ALONG THE TOP EDGE OF THE BOTTOM HALF MOON SHAPED COVER.
303-3440	[2]	FILM-IDENTIFICATION (CAT)
		INSTALL ONE FILM ON THE RH & LH SIDE OF THE GENERATOR TERMINAL BOX, AT THE TOP LH CORNER OF THE TERMINAL BOX, ALIGN EACH FILM WITH THE EDGES OF THE TERMINAL BOX COVER.
7W-5893	[4]	FILM-INFORMATION (GENERATOR LIFTING)
		INSTALL ONE DIRECTLY ABOVE EACH LIFTING HOLE ON GENERATOR BARREL.
118-8452	[1]	FILM-INFORMATION (GENERATOR)
		INSTALL FILM ON THE RH SIDE OF THE GENERATOR BARREL, CENTERED FROM THE FRONT TO BACK, APPROX. 100MM DOWN FROM THE CENTER LINE AT THE TOP OF THE GENERATOR. (INSTALL FILM ON THE BARREL COVER IF POSSIBLE.) INSTALL CLEAR LAMINATE OVER FILM.
225-3224	[3]	FILM-WARNING (AUTOMATIC ENGINE START)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED ABOVE THE CRUSH WARNING FILM, AND ONE FILM ON THE REAR OF THE TERMINAL BOX, CENTERED BELOW THE 229-5047 FILM.
225-3227	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON EACH SIDE OF THE GENERATOR BARREL, DIRECTLY ON THE GENERATOR BARREL,
		NOT ON THE BARREL COVER. IF THERE IS NO BARREL COVER, CENTER FILMS ON EACH SIDE THE BARREL FROM FRONT TO REAR, AND ON THE RH SIDE, CENTER FILM BELOW THE 118-8452 GLPS GENERATOR INFO FILM.
229-5047	[3]	FILM-WARNING (SHOCK HAZARD, READ OMM)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED ABOVE THE AUTO START WARNING, AND ONE FILM ON REAR OF THE TERMINAL BOX, CENTERED BELOW THE CATERPILLAR TRADEMARK DECAL.
Y		SEPARATE ILLUSTRATION

#M00770020864

463-0164: GENERATOR AR

GENERATOR AR

463-0164 GENERATOR AR
S/N G1B1-UP; TZK1-UP; FLX1-UP
50/60-HERTZ. LOW VOLTAGE
ALSO AN ATTACHMENT

i05979302 M0077002

For full view, you need register

Parts for your C32 GENERATOR SET:

CATERPILLAR SIS

Part No	Qty	Parts name
463-0163 Y	[1]	GENERATOR GP
228-4798	[1]	FILM-IDENTIFICATION (GROUND)
		INSTALL NEAR GENERATOR GROUND BOLT OR GENERATOR GROUND CUSTOMER CONNECTION POINT.
303-3433	[1]	FILM-IDENTIFICATION (CATERPILLAR)
		INSTALL FILM ON THE REAR PANEL OF THE GENERATOR TERMINAL BOX, CENTERED APPROX. 30MM FROM THE TOP OF THE REAR PANEL, IF THERE IS AN AIR CLEANER INSTALLED, MOVE FILM BELOW AIR CLEANER CENTERED ALONG THE TOP EDGE OF THE BOTTOM HALF MOON SHAPED COVER.
303-3440	[2]	FILM-IDENTIFICATION (CAT)
		INSTALL ONE FILM ON THE RH & LH SIDE OF THE GENERATOR TERMINAL BOX, AT THE TOP LH CORNER OF THE TERMINAL BOX, ALIGN EACH FILM WITH THE EDGES OF THE TERMINAL BOX COVER.
7W-5893	[4]	FILM-INFORMATION (GENERATOR LIFTING)
		INSTALL ONE DIRECTLY ABOVE EACH LIFTING HOLE ON GENERATOR BARREL.
118-8452	[1]	FILM-INFORMATION (GENERATOR)
		INSTALL FILM ON THE RH SIDE OF THE GENERATOR BARREL, CENTERED FROM THE FRONT TO BACK, APPROX. 100MM DOWN FROM THE CENTER LINE AT THE TOP OF THE GENERATOR. (INSTALL FILM ON THE BARREL COVER IF POSSIBLE.) INSTALL CLEAR LAMINATE OVER FILM.
225-3224	[3]	FILM-WARNING (AUTOMATIC ENGINE START)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED ABOVE THE CRUSH WARNING FILM, AND ONE FILM ON THE REAR OF THE TERMINAL BOX, CENTERED BELOW THE 229-5047 FILM.
225-3227	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON EACH SIDE OF THE GENERATOR BARREL, DIRECTLY ON THE GENERATOR BARREL,
		NOT ON THE BARREL COVER. IF THERE IS NO BARREL COVER, CENTER FILMS ON EACH SIDE THE BARREL FROM FRONT TO REAR, AND ON THE RH SIDE, CENTER FILM BELOW THE 118-8452 GLPS GENERATOR INFO FILM.
229-5047	[3]	FILM-WARNING (SHOCK HAZARD, READ OMM)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, CENTERED ABOVE THE AUTO START WARNING, AND ONE FILM ON REAR OF THE TERMINAL BOX, CENTERED BELOW THE CATERPILLAR TRADEMARK DECAL.
Y		SEPARATE ILLUSTRATION

#M00770020865

463-0166: GENERATOR AR

GENERATOR AR

463-0166 GENERATOR AR
S/N TZK1-UP; FLX1-UP
AN ATTACHMENT

i05963725 M0077002

For full view, you need register

Parts for your C32 GENERATOR SET:

CATERPILLAR SIS

Pos.	Part No	Qty	Parts name	Comments
	463-0165 Y	[1]	GENERATOR GP
	Y		SEPARATE ILLUSTRATION

#M00770020866

492-7300: GENERATOR AR

GENERATOR AR

492-7300 GENERATOR AR
S/N G1F1-UP; TZK1-UP; FLX1-UP
60-HERTZ. LOW VOLTAGE
ALSO AN ATTACHMENT

i06602040 M0077002

For full view, you need register

Parts for your C32 GENERATOR SET:

CATERPILLAR SIS

Part No	Qty	Parts name
492-7301 Y	[1]	GENERATOR GP
228-4798	[1]	FILM-IDENTIFICATION (GROUND)
		INSTALL NEAR GENERATOR GROUND BOLT OR GENERATOR GROUND CUSTOMER CONNECTION POINT.
303-3433	[1]	FILM-IDENTIFICATION (CATERPILLAR)
		INSTALL FILM ON THE REAR PANEL OF THE GENERATOR TERMINAL BOX, CENTERED APPROX. 30MM FROM THE TOP EDGE OF THE LOWER TERMINAL BOX COVER.
303-3440	[2]	FILM-IDENTIFICATION (CAT)
		INSTALL ONE FILM ON THE RH & LH SIDES OF THE GENERATOR TERMINAL BOX, AT THE TOP LH CORNER OF THE LOWER TERMINAL BOX COVER, ALIGN EACH FILM WITH THE EDGES OF THE COVER.
		IF THERE IS A CIRCUIT BREAKER, MOVE FILM TO THE BOTTOM OF THE COVER, BELOW THE CIRCUIT BREAKER, ALIGN FILM WITH THE EDGES OF THE COVER.
7W-5893	[4]	FILM-INFORMATION (GENERATOR LIFTING)
		INSTALL ONE DIRECTLY ABOVE EACH LIFTING HOLE ON GENERATOR BARREL.
118-8452	[1]	FILM-INFORMATION (GENERATOR)
		INSTALL FILM ON THE RH SIDE OF THE GENERATOR BARREL, CENTERED FROM FRONT TO BACK, APPROX. 100MN DOWN FROM THE CENTER LINE AT THE TOP OF THE GENERATOR.
		INSTALL FILM ON THE BARREL COVER IF AVAILABLE.
		INSTALL CLEAR LAMINATE OVER FILM.
225-3224	[3]	FILM-WARNING (AUTOMATIC ENGINE START)
		INSTALL ONE FILM ON THE REAR OF THE GENERATOR TERMINAL BOX DIRECTLY BELOW THE ELECTROCUTION HAZARD FILM, AND ONE FILM ON THE RH AND LH SIDES OF THE TERMINAL BOX, CENTERED ABOVE THE CRUSH WARNING. IF THE GENERATOR IS EQUIPPED WITH CIRCUIT BREAKER ON EITHER SIDE, MOVE FILM ABOVE THE BREAKER COVER DIRECTLY BELOW THE 229-5047 FILM.
225-3227	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON EACH SIDE OF THE GENERATOR BARREL, DIRECTLY ON THE GENERATOR BARREL, NOT ON THE BARREL COVER. IF THERE IS NO BARREL COVER, CENTER FILMS ON EACH SIDE THE BARREL FROM FRONT TO REAR, AND ON THE RH SIDE, CENTER FILM BELOW THE 118-8452 GLPS GENERATOR INFO FILM.
229-5047	[3]	FILM-WARNING (SHOCK HAZARD, READ OMM)
		INSTALL ONE FILM ON THE REAR OF THE GENERATOR TERMINAL BOX, CENTERED AT THE TOP OF THE TERMINAL BOX BELOW THE CATERPILLAR DECAL, AND ONE FILM ON THE RH AND LH SIDES OF TERMINAL BOX CENTERED ABOVE THE AUTO START WARNING. IF THE GENERATOR IS EQUIPPED WITH A CIRCUIT BREAKER ON EITHER SIDE, MOVE FILM ABOVE THE BREAKER COVER CENTERED AT THE TOP EDGE OF THE TERMINAL BOX COVER.
Y		SEPARATE ILLUSTRATION