521-1540 PANEL GP-INSTRUMENT (CHG -00 THRU -02) PART OF 521-1560, 521-1570 PANEL GP-ELECTRONIC C280-16

OPERATOR STATION

PANEL GP

0. 521-1540 PANEL GP-I

GENERATORS

REGULATOR GP-VOLTAGE

1. 521-1563 POTENTIOME

SERVICE EQUIPMENT AND SUPPLIES

CHARTS & FILMS

2. 6L-4502 CHART-PLAT

PROTECTION GP

3. 443-8082 COVER GP-P
4. 469-7256 COVER GP-P
5. 503-5953 COVER GP-P
6. 505-6872 COVER GP-P

SHIPPING GP

7. 134-5926 COVER-TARP
8. 134-6228 COVER-TARP
9. 249-5224 COVER-TARP
0. INFORMATION

INDUSTRIAL ENGINE C280-16 INDUSTRIAL ENGINE R4M
C280–16 Marine Engine R4M00001-UP M0080110 C280-16 R4M (2017)

OPERATOR STATION

PANEL GP

521-1570 PANEL GP-ELECTRONIC

444-1275 PANEL GP-INSTRUMENT

521-1540 PANEL GP-INSTRUMENT

521-1563 POTENTIOMETER AS

#M00801100710

521-1540: PANEL GP-INSTRUMENT

PANEL GP-INSTRUMENT

521-1540 PANEL GP-INSTRUMENT (CHG -00 THRU -02)
PART OF 521-1560, 521-1570 PANEL GP-ELECTRONIC

i06870774 M0080110

5211540 PANEL GP-INSTRUMENT Parts scheme

For full view, you need register

Parts for your C280-16 INDUSTRIAL ENGINE:

CATERPILLAR SIS

Pos.	Part No	Qty	Parts name
1.		[2]	RESISTOR
2.	7K-1181	[2]	STRAP-CABLE
3.	096-6166	[8]	WASHER-HARD (4.5X9X1-MM THK)
4.	147-1960 E		RAIL (21-CM EACH)
5.	166-6162	[8]	DUCT-WIRE
6.	166-6165	[1]	DUCT-WIRE
7.	173-5413	[12]	CLAMP
8.	224-9828	[1]	FILM-WARNING (SHOCK HAZARD)
9.	447-6619	[10]	RELAY (DOUBLE POLE)
10.	447-6623	[1]	COVER-TERMINAL
11.	448-4865	[1]	STRIP-CONTACT
12.	459-6565	[1]	STRIP-CONTACT
13.	460-2362	[10]	STRIP-CONTACT
14.	460-2366	[2]	STRIP-CONTACT
15.	460-2454	[2]	BOLT
16.	480-9084	[1]	WASHER (7.112X12.7X2.032-MM THK)
17.	493-3558	[3]	CIRCUIT BREAKER (5-AMPERE, 1-POLE)
18.	493-3559	[3]	CONTACTOR-AUXILIARY
19.	493-3563	[14]	ADAPTER
20.	498-8321	[7]	ADAPTER
21.	498-8331	[1]	DIODE
22.	498-8336	[1]	ADAPTER AS
23.	500-4650	[15]	BLOCK-TERMINAL
24.	500-4651	[1]	STRIP-CONTACT (800-VOLT)
25.	500-4653	[1]	SWITCH-OPERATOR (3-POSITION, MOMENTARY)
26.	500-4654	[1]	SWITCH-OPERATOR (2-POSITION)
27.	500-4655	[5]	SWITCH-OPERATOR (2-POSITION, MAINTAINED)
28.	500-4669	[1]	FILM-IDENTIFICATION (MANUAL START, STOP)
29.	500-4670	[1]	FILM-IDENTIFICATION (START DISABLE)
30.	500-4671	[1]	FILM-IDENTIFICATION (ENGINE SHUTDOWN OVERRIDE)
31.	500-4672	[1]	FILM-IDENTIFICATION (MANUAL PRELUBE)
32.	500-4673	[1]	FILM-IDENTIFICATION (CRANK OVERRIDE)
33.	502-5593	[1]	COVER
34.	502-5594	[2]	NUT-SPACER
35.	503-1580	[2]	WASHER (10.5X20X2-MM THK)
36.	521-1527	[6]	BLOCK-DIODE
37.	521-1528	[1]	FILM-IDENTIFICATION (CRANKING MOTOR SELECT)
38.	521-1529	[1]	FILM-IDENTIFICATION (RAPID START, STOP)
39.	521-1541	[1]	PLATE AS
40.	521-1543	[1]	MARKER AS-TERMINAL
41.	521-1545 Y	[1]	HARNESS AS-PANEL (PRIMARY)
42.	521-4250	[67]	BLOCK-TERMINAL
43.	528-0988	[5]	COVER-END
44.	528-0989	[2]	COVER-END
45.	033-4815	[2]	SCREW-MACHINE (6-32X1.5-IN)
46.	1H-3338	[1]	LOCKWASHER
47.	259-8175 M	[1]	BOLT (M6X1.0X16-MM)
48.	3L-8187	[4]	LOCKWASHER
49.	4B-2041	[6]	NUT (6-32-THD)
50.	4B-4863	[31]	WASHER (4.7X11X1.2-MM THK)
51.	4P-7581	[2]	CLIP (LADDER)
52.	8T-0337 M	[31]	SCREW-MACHINE (M4X0.7X12-MM)
	E		ORDER BY THE CENTIMETER
	M		METRIC PART
	Y		SEPARATE ILLUSTRATION

#M00801100711

521-1563: POTENTIOMETER AS

POTENTIOMETER AS

521-1563 POTENTIOMETER AS (CHG -00)
PART OF 521-1561 CONTROL GP-THROTTLE

i07416754 M0080110

For full view, you need register

Parts for your C280-16 INDUSTRIAL ENGINE:

CATERPILLAR SIS

Pos.	Part No	Qty	Parts name
1.	124-0284 E		TUBE-HEAT SHRINK (3.2-MM DIA)(12-CM)
2.	521-1564	[1]	HARNESS AS-WIRING
	102-8805	[1]	KIT-RECEPTACLE (6-PIN)
			(INCLUDES RECEPTACLE AS & WEDGE)
	9X-3401	[6]	PIN-CONNECTOR (16-GA TO 18-GA)
	E		ORDER BY THE CENTIMETER

#M00801100712

6L-4502: CHART-PLATE & FILM

CHART-PLATE & FILM

6L-4502 CHART-PLATE & FILM (CHG -0521)

i07037525 M0080110

For full view, you need register

Parts for your C280-16 INDUSTRIAL ENGINE:

CATERPILLAR SIS

Part No	Qty	Parts name
	[1]	FILM-IDENTIFICATION (CERTIFICATION)
		CONTACT YOUR LOCAL DEALER
		INSTALL FILM ON THE RH REAR VALVE COVER, VISIBLE FROM THE SIDE OF THE ENGINE.
7W-5890	[2]	FILM-INFORMATION (STANDARD ROTATION)
		INSTALL FILM ON THE TOP OF THE FLYWHEEL HOUSING, IF THE HOUSING IS NOT AVAILABLE, INSTALL FILM ON THE REAR CAM GEAR COVER.
224-9828	[1]	FILM-WARNING (SHOCK HAZARD)
		INSTALL FILM ON THE FACE OF THE ECM CONTROL BOX IN THE TOP LH CORNER OF THE BOX.
228-3581	[1]	FILM-WARNING (DO NOT OPERATE, READ OMM)
		INSTALL FILM ON THE FACE OF THE ECM CONTROL BOX IN THE TOP RH CORNER OF THE BOX.
308-4479		FILM-WARNING (NO WELD, READ OMM)
		INSTALL FILM ON THE FACE OF THE ECM CONTROL BOX CENTERED AT THE BOTTOM OF THE BOX.
225-3226	[2]	FILM-WARNING (HOT SURFACE)
		INSTALL ONE FILM ON THE RH AND LH SIDES OF THE ENGINE ON THE FIRST AVAILABLE ROCKER BASE NEAREST THE TURBOCHARGER VISIBLE FROM THE SIDE OF THE ENGINE.
228-3369	[2]	FILM-WARNING (DO NOT OPERATE, READ OMM)
		INSTALL ONE FILM ON THE RH AND LH SIDES OF THE ENGINE ON THE FIRST AVAILABLE ROCKER BASE NEAR THE CENTERLINE OF THE ENGINE VISIBLE FROM THE SIDE OF THE ENGINE.
233-6084	[2]	FILM-WARNING (FIRE, STOP ENGINE, DO NOT OPEN)
		INSTALL ONE FILM ON EACH SIDE OF THE ENGINE, ON THE RH SIDE CENTERED ON THE FIRST VISIBLE CRANKCASE COVER FROM THE REAR, AND LH SIDE CENTERED ON THE FIRST VISIBLE CRANKCASE COVER FROM THE FRONT.
115-5852	[1]	PLATE & FILM GP (ENGINE INFORMATION)
		CONTACT YOUR LOCAL DEALER
		INSTALL FILM ON THE CYL. #15 ROCKER BOX VISIBLE FROM THE SIDE OF THE ENGINE.INSTALL CLEAR LAMINATE OVER FILM.
	[2]	PLATE-IDENTIFICATION (CAT C280)
		INSTALL ONE PLATE ON EACH SIDE OF THE ENGINE, ON THE FIRST VISIBLE CAM COVER FROM THE RH REAR AND THE FIRST VISIBLE CAM COVER FROMH FRONT, IF EITHER LOCATION IS NOT VISIBLE MOVE FILM TO THE FIRST VISIBLE LOCATION ON THAT SIDE OF THE ENGINE.
3N-3790	[1]	PLATE-SERIAL NUMBER (ENGINE)
		CONTACT YOUR LOCAL DEALER REFLATTEN AFTER STAMPING INSTALL ON LH SIDE OF CYLINDER BLOCK BETWEEN REAR TWO CRANKCASE COVERS USING 7B-3028 DRIVE SCREWS.
		STAMP SERIAL NUMBER IN BLOCK JUST BELOW PLATE IN FIGURES 6 HIGH.
7B-3028	[1]	SCREW-DRIVE (NO 4X 3/16-IN)
		INSTALL ENGINE SERIAL NUMBER PLATE.