MAGNET 2031226 - Caterpillar

Table 2
Required Parts List
Item Qty New Part Number Part Name Former Part Number(1)
1 1 552-8841 Plate -
2 2 8T-4121 Hard Washer -
3 2 8T-4136 Bolt -
4 1 552-8842 Plate -
5 1 552-8840 Pipe -
6 2 7Y-5247 U-Bolt 119-5917
7 4 7X-7729 Washer -
8 8 8T-4133 Nut -
9 1 552-8838 Hose 476-0262
10 2 8T-4984 Hose Clamp -
11 1 552-8839 Hose -
(1) The former part number listed is for reference only and may differ.Replacement Procedure
Illustration 1 g06270329
(A) Clip
(B) Hose
(C) Bracket
Remove existing hose (B), clips (A), and bracket (C). Some of the parts will be reused later.
Illustration 2 g06270330
(1) 552-8841 Plate
(2) 8T-4121 Hard Washer
(3) 8T-4136 Bolt
(4) 552-8842 Plate
(D) 296-7033 Spacer (reuse)
(E) 7X-0515 Hard Washer (reuse)
(F) 447-1707 Bolt (reuse)
Install new plates (1) and (4). Tighten two bolts (3) to a torque of 55 10 N m (40 7 lb ft). Tighten two bolts (F) to a torque of 240 40 N m (177 29 lb ft).
Illustration 3 g06270332
(5) 552-8840 Pipe
(6) 7Y-5247 U-Bolt
(7) 7X-7729 Washer
(8) 8T-4133 Nut
Install new pipe (5) with U bolt (6) without tightening.Note: Do no tighten the nuts on the U bolt in this step to adjust hose and pipe mounting.
Illustration 4 g06354515
(9) 552-8838 Hose
(10) 8T-4984 Hose Clamp
(11) 552-8839 Hose
(G) 8T-6703 Hose Clamp (reuse)
Install new hoses (9) and (11), and clamps (10) and (G). Tighten all the clamps to a torque of 11 1 N m (97 9 lb in). Refer to Illustration 4 for the clamp direction.
Illustration 5 g06270334
(H) Bolt
(J) Bolt
Tighten four nuts (H) on the U bolts to a torque of 10 3 N m (88 26 lb in). Tighten four nuts (J) to a torque of 30 7 N m (265 62 lb in).