MAGNET GP 3157109 - Caterpillar

Illustration 1 g02481937
(1) Back cushion angle handle (2) Fore/aft handle (3) Ride Zone Indicator (4) Height/Weight adjustment (5) Ride firmness adjustmentLift handle on back cushion angle handle (1) and let the back cushion spring forward, or lean backward into the cushion. Release the handle at the desired position.Lift handle on fore/aft handle (2) to move the seat forward or rearward. Release the handle at one of several positions.Ride zone indicator (3) should be used to determine if the suspension is adjusted too high or low. Adjust suspension height until the black line is in the middle of the indicator window.Use the height and weight adjustment switch (4) in order to raise the suspension. Press rocker switch left to raise the seat and press right to lower seat. To operate the ride firmness adjustment (5), push lever down to increase the ride firmness. Pull lever up to decrease the firmness. Release the lever at one of several positions.Seat Cushion Adjustment
Illustration 2 g02481481
(6) Seat cushion tiltThe seat cushion tilt (6) is adjusted by a pin in a groove. Grasp the seat pan and rotate forward-up-and-back for steeper angle positions or forward-down-and-back for shallower angle positions.Lumbar Adjustment
Illustration 3 g02482316
(7) Lumbar adjustment knobRotate knob (7) counterclockwise in order to increase lumbar support. Rotate knob (7) clockwise in order to decrease lumbar support.Armrest Adjustment
Illustration 4 g02482418
(8) Armrest adjustment barrelRotate barrel (8) in order to adjust the angle of the armrest. The armrest can be rotated to a vertical position when not needed.Shoulder Belt Adjustment
Illustration 5 g02482139
(9) Seat belt adjustment leverSqueeze the lever (9) on the side of the vertical post down toward the knob below. Adjust the height of the shoulder belt. Release the lever at one of several positions.Premier Seat Controls
Illustration 6 g02481436
(3) Heat/Ventilate mode selection (4) Heat/Ventilate level adjustmentIn order to use Heat/Ventilate mode selection switch (3), press right to activate cool mode and press left to activate heat mode.In order to use Heat/Ventilate level switch (4), press rocker switch down for low level and press rocker switch up for high level. Press rocker switch to middle for off.