MAGNETO A. 6B3561 - Caterpillar

Flash Program The Grade/Slope Control (ECM) For H-Series Motor Graders
Perform the following procedure in order to flash program the ECM. The ECM is flashed in order to upgrade the software. The new software will allow the ECM to communicate with the AccuGrade System. The Caterpillar Electronic Technician (Cat ET) contains the program WinFlash. WinFlash is used in order to load software into the ECM. The following procedure is used in order to FLASH software into the ECM.
Procedure
Connect the 7X-1425 Data Link Cable between the 7X-1700 Communication Adapter and the Electronic Technician.
Connect the 139-4166 Data Link Cable between the 7X-1700 Communication Adapter and the diagnostic connector of the machine.
Use WinFlash in order to load the software. Refer to Table 2 for the part number of the software.
Table 1
Machines     Software Part Number    
Motor Graders ( H- Series)     305-7418    Note: Flash programming is NOT allowed if the engine is running, or the machine is moving.Flash Program The AccuGrade Components
Refer to "Flash Procedure" in order to flash program the system components. The system components are flashed in order to upgrade the software. The new software will allow the system components to communicate with the ECM and each other. The Caterpillar Electronic Technician (ET) contains the program WinFlash. WinFlash is used in order to load software into the system components. The following procedure is used in order to FLASH software into the system components.
Do not stop the process. The ECM will be damaged and need to be replaced.
Flash Procedure
Note: Flash programming is NOT allowed if the engine is running, or the machine is moving.
Connect the 7X-1425 Data Link Cable between the 7X-1700 Communication Adapter and the Electronic Technician.
Connect the 139-4166 Data Link Cable between the 7X-1700 Communication Adapter and the diagnostic connector of the machine.
Use WinFlash in order to load the software. Refer to Table 2 for the part number of the software. 297-0153
Table 2
Software Part Number     Component     Description    
297-0154     Laser receiver     Monitor Software Gp    
297-0153     Electronic mast     Machine Software Gp