MANIFOLD-EXHAUST 1992264 - Caterpillar

Excavator:
330D (S/N: EAH1-UP; MEY1-UP)
330D L (S/N: GBC1-UP; NBD1-UP; MAG1-UP; B6H1-UP; THJ1-UP; FFK1-UP; LRM1-UP; ERN1-UP; JLP1-UP; MWP1-UP; HAS1-UP; RAS1-UP; EDX1-UP; T2Y1-UP)
330D MH (S/N: C5K1-UP; PEL1-UP; LEM1-UP)
330D FM (S/N: E4K1-UP; H3K1-UP; L2K1-UP)
330D LN (S/N: GGE1-UP)
Testing and Adjusting, KENR5275, "330D Forest Machines Hydraulic System". This module is part of the following Service Manual, RENR9898.Testing and Adjusting, KENR7869, "330D Material Handler Hydraulic System". This module is part of the following Service Manual, RENR9680.Testing and Adjusting, RENR9585, "330D Excavator Hydraulic System". This module is part of the following Service Manuals, KENR6570, RENR7450, and RENR9920.Testing and Adjusting, RENR9679, "330D Excavator Hydraulic System". This module is part of the following Service Manual, RENR9680.Testing and Adjusting, RENR9909, "330D Material Handler Hydraulic System". This module is part of the following Service Manual, RENR9159.The value for power shift pressure has changed. The value for power shift pressure is listed in Step 4 in the test procedure for constant horsepower flow control for the main hydraulic pump flow. Replace Step 4 in the test procedure with the information that follows.
Start Service Mode and input a fixed power shift pressure of 2850 50 kPa (415 7.5 psi).The value for power shift pressure is also listed in two notes in the test procedure for constant horsepower flow control for the main hydraulic pump flow. Replace the two notes in the test procedure with the two notes that follow.Note: The value for power shift pressure on the monitor may not always match the pressure reading on the pressure gauge. Adjust the value on the monitor until the desired power shift pressure is attained on the pressure gauge that is connected to the pressure tap for power shift pressure. The actual power shift pressure must be 2850 50 kPa (415 7.5 psi) on the pressure gauge.Note: Specifications for output flow rates are based on a power shift pressure at the pump of 2850 50 kPa (415 7.5 psi). The output flow rate changes approximately 10 L/min (2.6 US gpm) for each 100 kPa (14 psi) of power shift pressure in the lower range of the constant horsepower control. The output flow rate changes approximately 3 L/min (0.8 US gpm) for each 100 kPa (14 psi) of power shift pressure in the higher range of the constant horsepower control.