MANIFOLD-EXHAUST 2006557 - Caterpillar

Illustration 1 g03888308
Typical example
Table 1
Item Qty Part Specification Description
- - - Use the following procedure to tighten the track bolts:
1. Torque to 340 70 N m (251 52 lb ft).
2. Tighten the standard track bolts to an additional turn of 120 5 degrees.
3. Tighten the master link bolts to an additional turn of 180 5 degrees.
- - - The maximum assembly force for the track link assembly is 710000 N (159615 lb).
- - - The reference setting force is 520000 N (116901 lb).
A Distance between the bolt holes is 146.10 0.80 mm (5.752 0.032 inch).
B Distance between the bolt holes is 204.10 0.80 mm (8.035 0.032 inch).
C - - Distance between the bolt holes is 146.10 0.39 mm (5.752 0.015 inch).
D - - Distance between the bolt holes is 204.10 0.39 mm (8.035 0.015 inch).
E - - Distance between the bolt holes is 146.10 0.80 mm (5.752 0.032 inch).
F - - Distance between the bolt holes is 204.10 0.80 mm (8.035 0.032 inch).
G - - The plug must not be recessed below the surface of the stopper after assembly.
Distance from the end of the plug to the surface of the stopper is 0.0 to 2.0 mm (0.00 to 0.08 inch).
H - - Distance from the end of the pin to the surface of the stopper is 8.0 4.0 mm (0.31 0.16 inch).
J - - Protrusion at one end of the pin is 4.9 0.8 mm (0.20 0.03 inch).
K - - Bushing protrusion at each end is 1.80 0.13 mm (0.071 0.005 inch).
- - - End play for the link assembly is 0.00 to 0.20 mm (0.000 to 0.008 inch).