MANIFOLD & LINES GP-STEERING 2164063 - Caterpillar

Note: For Motor Graders, Wheel Loaders, and Articulated Trucks the system will only be active in reverse gear.Camera View
This function allows the operator to see objects around the machine to aid in object identification. The camera function is enabled whenever the system is powered up. The camera view is available in all machine states. The camera view will occupy approximately 90% of the main screen.The forward camera will be displayed in forward gear. The rear camera will be displayed in reverse gear. The systems default view for neutral and stand by view is the forward camera view.The camera view will also be switched automatically when there is a side detection in forward gear. In forward gear, the view will switch to show front or side camera views depending on object proximity to the machine. In reverse, the rear camera view will be the only view automatically displayed.Note: For Motor Graders, Wheel Loaders, and Articulated Trucks the system will only be active in reverse gear.Camera View Memory
The camera will have two camera memory views. The first will be the "Neutral Memory View". When in neutral the camera view for the last manually selected camera view will be remembered. If no view has been selected, the monitor will display the front view. If you wish to change this manually select a camera view with the arrow button when in neutral gear. Each time neutral gear is selected, after manually selecting a camera view in neutral, that manually selected camera view will appear.The second camera memory view is the "Standby Memory View". When the system enters standby, the camera view that was last manually selected in standby will appear. If no view has been selected, the front camera will be shown. If you wish to change this, manually select a camera view using the arrow buttons when in "Standby Mode". The camera memory will reset anytime the systems is turned OFF.System Information and Warning Display
This portion of the main screen has two functions. The first function is informing the operator of the status of the system. The status of the system can be active, standby, or faulted.Active
Illustration 9 g02720631
The system is in the active state when the machine is stopped or when the reverse gear is selected. Additionally, the system remains active in the FORWARD gear as long as the threshold set by the "Object Detection Standby Mode" parameter has not been met. While the machine is in the active state, the operator will be warned of objects that are detected by the system. A green indicator located on the display screen signifies the active state. Refer to Illustration 9.Note: The system remains in the active state anytime the transmission is place in the REVERSE gear.Standby
Illustration 10 g02665158
The system can be configured to run in one of two different standby modes:Distance - In "Distance" based standby, once the machine travels 20 m (65 ft) the system goes into standby mode. When the machine stops for "x" seconds the system returns to active mode.