MANIFOLD & VALVE GP 2676715 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-9612 Silicone Sealant 1
B — Loctite LV Core Plug Sealant 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g06295353
If cup plugs (11) were removed or the rear housing is being replaced, use Tooling (B) on cup plugs (11) and install to Dimension (X).Dimension (X) ... 1.25 0.25 mm (0.05 0.01 inch)
Apply Tooling (A) to the bottom of the rear housing at the junction of the cylinder block and the engine oil pan.
Illustration 2 g02223273
Illustration 3 g02223413
Bolt tightening sequence
Attach a suitable lifting device to rear housing (3). The weight of rear housing (3) is approximately 84 kg (185 lb).
Position the gasket on rear housing (3).
Position rear housing (3) on the cylinder block. Install bolts (6). Tighten bolts (3) in a numerical sequence to a torque of 55 10 N m (41 7 lb ft).
Trim the gasket between the rear housing and the cylinder block even with the bottom of the rear housing.
Illustration 4 g02223255
Install bolts (4).
Connect hose assembly (5).
Illustration 5 g02223214
Install bolts (2) that hold the engine oil pan to rear housing (3).
Tighten all the bolts that hold the engine oil pan evenly to raise the engine oil pan into position.End By:
Install the rear gear group. Refer to Disassembly and Assembly, "Gear Group (Rear) - Install".