MANIFOLD GP-HYDRAULIC 2714213 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Place identification marks on all tube assemblies for installation. Plug all lines and tube assemblies in order to prevent contamination.
Turn the fuel supply to the OFF position.
Illustration 1 g01332532
Typical example
Illustration 2 g01324910
Typical example
If necessary, loosen the dipstick tube (not shown).
Disconnect fuel injection lines (1) from fuel injectors (3) .
Disconnect fuel injection lines (1) from fuel injection pump (5) .Note: Do not allow the unions to turn in the fuel injection pump when the fuel line nuts are loosened. Use two wrenches in order to disconnect the fuel injection lines from the fuel injection pump.
Remove clamps (4) and remove fuel injection lines (1) .
Use suitable caps in order to plug the open ports of the fuel injection pump and the fuel injectors immediately.
Disconnect tube assembly (6) from fuel injector (3). Disconnect tube assembly (6) from fuel injection pump (5). Remove bolts (7) and remove tube assembly (6) .
Remove hoses (2) from fuel injectors (3) .Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     276-1216     Injector Pipe Nut Tool     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01332532
Typical example
Illustration 4 g01324910
Typical example
Install hoses (2) to fuel injectors (3) .
Position tube assembly (6) onto the engine and install bolts (7). Tighten the bolts to a torque of 18 N m (13 lb ft).
Connect tube assembly (6) to fuel injectors (3). Connect tube assembly (6) to fuel injection pump (5) .
Remove the caps from fuel injectors and from the fuel injection pump. Loosely install fuel injection lines (1) to fuel injection pump (5) and to fuel injectors (3) .
Install clamps (4). Tighten the clamps securely.
Use Tooling (A) to tighten the nuts on fuel injection lines (1) to a torque of 30 N m (22 lb ft).Note: Do not allow the unions to turn in the fuel injection pump when the fuel line nuts are tightened.
If necessary, tighten the dipstick tube (not shown) to a torque of 9 N m (80 lb in).
Turn the fuel supply to the ON position.
Prime the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime" for more information.