MANIFOLD GP-VALVE 2922034 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-7505     Hydraulic Jack     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.
Drain the engine oil from the engine oil pan into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".
Illustration 1 g01169509
Disconnect hose (1) from engine oil pan (2) .
Use Tooling (A) to support engine oil pan (2) .
Illustration 2 g01169511
Remove bolts (3) and engine oil pan (2) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-7505     Hydraulic Jack     1    
B     8T-9022     Silicone Gasket     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Apply Tooling (B) to the sealing surface of the engine oil pan and on the connecting joints of the front plate, gasket for the engine oil pan, cylinder block, and the flywheel housing. Install a new gasket on the engine oil pan.
Illustration 3 g01169511
Use Tooling (A) to place engine oil pan (2) in position. Install bolts (3) .
If the drain plug was removed, install the drain plug. Tighten the drain plug to a torque of 70 15 N m (52 11 lb ft).
If the pipe plugs were removed, install the pipe plugs. Tighten the pipe plugs to a torque of 82 10 N m (60 7 lb ft).
Illustration 4 g01169509
Connect hose (1) to engine oil pan (2) .
Refill the engine with engine oil. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".