MANIFOLD 2B1818 - Caterpillar

Mounting and Dismounting
Climb on or off the machine only where steps and/or grab irons are provided. Never jump on or off of the machine.Use both hands and face the machine when mounting or dismounting.Never get on or off of a moving machine.Learn the location of the emergency exits.Preparing to Start the Engine
Inspect the condition of the seat belt. Replace it if it is worn or damaged.Make certain all protective guards and covers are secured in place.Inspect the machine for potential fire hazards.Make sure the machine is equipped with proper lighting as required by job conditions.Starting the Engine
Do not start the engine or move any of the controls if a DO NOT OPERATE or warning tag is attached to the controls.Make sure no one is working on, under, or close to the machine before starting the engine.Move all implement controls to hold or neutral before starting the engine.Start and operate the engine only in a well ventilated area. In an enclosed area, vent the engine exhaust to the outside.Preparing to Operate
Fasten the seat belt securely.Check all controls and protective devices to make sure they are working properly while moving slowly in an open area:1. Steering2. All brakes3. Governor control4. Hydraulic functions5. Devices such as lights, travel alarm, horn, etc.See the Lubrication and Maintenance Guide for adjustments if they are needed.Operating
Operate the controls only while seated.Do not allow riders on the machine unless an additional seat, seat belt and rollover protection is provided for each rider.The operator must satisfy himself that no one will be endangered before moving the machine.Be careful to avoid tipping when working on hills, banks or slopes and also when crossing ditches, ridges or other obstructions.Stay a safe distance from the edge of cliffs, overhangs or slide areas.If the machine begins to slide on a grade, dispose of the load immediately and turn the machine downhill.Do not exceed the rated load capacity of the machine. If the machine is not on level ground, capacities will vary.When loading trucks, never swing over the cab. Make sure the driver is out of the truck during loading.Avoid fast swings and hoists or sudden stops.Check for adequate tail swing clearance before operating the machine.Beware of reduced stability when swinging over the side of the track.When working in a pit or near a high bank, alert pit men immediately if a cave-in appears imminent.Use short slings to prevent excessive load swing.Use caution on slopes. Tipping can occur if you operate with a load beyond a safe operating radius.Keep other machines away from the edge of an excavation when you are digging.Swing the boom to the upper side of a hill to avoid tipping, except when using it as a crutch.For long moves, position the boom in the direction of travel.Know the exact location of buried cables and pipes. Mark them clearly.Move the machine away from the excavation before leaving it.Parking the Machine
Lower the equipment to the ground with slight down pressure. Engage the hydraulic and anti-travel lock lever. Stop the engine.