MANIFOLD 3143173 - Caterpillar

2. Install a 6V-9836 Tee between connection of 122-9034 Hose (1) and 6V-9836 Tee (2). Use two 6V-8397 O-ring seals. 3. Charge the 2G-8111 Accumulator with 690 69 kPa (100 psi) of nitrogen. This will need to be done before the installation of the accumulator because there will be no room for charging after installation. Install 2G-8111 Accumulator (3). Use a fabricated bracket or a 7I-3921 Clip, a 9B-7237 Bolt, and an 8T-4896 Washer to mount the accumulator to the front wall of the compartment under the cab as shown in the above illustration. The accumulator may be installed on the rear wall of the compartment under the cab if preferred.4. Install a 6V-8723 Elbow (4) on the end of 2G-8111 Accumulator (3). Use a 3K-0360 O-ring Seal.5. Install a 122-9034 Hose Assembly (5) between the 6V-9836 Tee and the 6V-8723 Elbow (4). Use two 6V-8397 O-ring Seals. If the accumulator is mounted in the rear wall, a longer hose will need to be used. To assemble a longer hose, use 122-6869 Hose and two 124-2114 Couplings.COPYRIGHT 2000 CATERPILLAR ALL RIGHTS RESERVED