MANIFOLD- 3217707 - Caterpillar

Connect one Tool (B2) to Tool (B1).
Connect Tool (C3) to Tool (C1). Connect Tool (C2) to Tool (C1).
Connect Tool (C) to Tool (B).Test Preparation
Drive the machine to a smooth, horizontal surface.
Illustration 4 g03704339
Move propel lever (4) to the NEUTRAL position.
Press parking brake switch (3) in order to change the status of the parking brake to "engaged". When the parking brake status is "engaged", an LED next to the parking brake switch will be illuminated.
Use travel mode switch (2) to select the PAVE mode. When the travel mode switch is set to PAVE mode, an LED next to pave symbol (1) will be illuminated.Note: The machine must be in PAVE mode in order to operate the screed lift system, hopper system, apron system and auger lift system.
Illustration 5 g03704791
Use screed float switch (6) to place the screed in the FLOAT position. When the screed is in the FLOAT position, an LED next to the screed float switch will illuminate. Lower the screed to the ground.
Press rpm decrease switch (7) for the throttle control once to operate the engine in low idle.
Illustration 6 g03704857
Shut off the engine. Either place machine power switch (8) in the OFF position or press and hold push to start switch (5) for 3 seconds. An LED next to the push to start switch will flash when the engine is in shutdown mode.Note: The engine may run for several minutes when placed in the shutdown mode.
If the engine was shut down using the push to start switch (5), move the machine power switch