MANIFOLD GP-INLET 4928268 - Caterpillar

Record the Following Parameters
Use Caterpillar Electronic Technician (ET) to verify and then record specific parameters. Record the parameters by using the "Steady State Data Logger" in Cat ET. The *.ssd format is required in order to supply the parameter information to Caterpillar.
Desired engine speed
Actual engine speed
Fuel position
FRC fuel limit position or "Smoke Limit Fuel Volume"
Boost pressure
Rated fuel limit or torque limit fuel volume
Fuel pressure
Fuel temperature
Inlet manifold temperature
Injection actuation pressure (HEUI engines)
Desired injection actuation pressure (HEUI engines)
Injection actuation current (HEUI engines)
Engine load factor
Fuel burn rate with fuel flow meter. (Using the fuel rate from the ECM is unacceptable.)
Exhaust temperature to turbochargers
Angle of engine installation
Air temperature at the turbocharger inlet
Fuel API rating
Restriction of the inlet fuelVerify the Fuel Flow Meter
Also, provide the following information concerning the Caterpillar fuel flow meter.
Date of last calibration
Part number of the actual fuel flow meter that is used
Table 1
Engine     Required Part Number    
C7 up to C18     179-0710 Meter Gp    
Larger than C18     154-8102 Meter Gp    Verify the Correct Calibration of the Dipstick
Verify that the dipstick has been correctly calibrated by draining the oil and refilling the oil to the correct oil level. Refer to your engine's Operation and Maintenance Manual for the correct oil level for your engine.Troubleshooting Chart for Engines with Low Power
Refer to Illustration 1 prior to contacting Caterpillar for support.
Illustration 1 g01287933