MANIFOLD ASSEM. 6P3076 - Caterpillar

Illustration 1 g00945595
(1) Ripper tip
(2) Shank protector (if equipped) When the ripper tip is worn close to the shank, replace the ripper tip. When the shank protector (if equipped) is worn close to the shank, replace the shank protector. If the tip is too blunt, the tip will not penetrate properly.
Raise the ripper. Place blocking under the ripper. Lower the ripper onto the blocking. The ripper should be high enough so that the ripper tip or the shank protector (if equipped) can be removed. Do not place the ripper too high.
If the ripper tip is worn, drive out the pin. Remove the tip and the shank pin retainer.
Do not reuse the retainer and the pin that were removed. Properly dispose of these items.
Clean the counter-bored hole in the shank for the retainer.
Install a new retainer and the new tip. Note: If labeled, install the proper surface of the retainer to the outside.
Illustration 2 g03588337
Direction of pin installation
Install a new pin from the same side as the retainer is installed in the shank. Drive the pin in the orientation shown in illustration 2 so that the groove in the pin will engage the retainer when properly installed. Note: The shank provides a stable support for the retainer when the pin is installed from the same side as the retainer.
If the shank protector is worn, drive out the pins. Remove the shank protector.
Do not reuse the retainers and the pins that were removed. Properly dispose of these items.
Clean the counter-bored holes in the shank for the retainers.
Install new retainers and the new shank protector. Note: If labeled, install the proper surface of the retainers to the outside.
Install new pins from the same side as the retainers are installed in the shank. Drive the pins in the orientation shown in illustration 2 so that the grooves in the pins will engage the retainers when properly installed. Note: The shank provides a stable support for the retainers when the pins are installed from the same side as the retainers.
Raise the ripper and remove the blocking.
Lower the ripper to the ground.