MANIFOLD AS 7N3175 - Caterpillar

Table 1
NUMERIC DISPLAY CODE FOR SPECIAL FUNCTION INPUTS    
Function Code     Identification     Description    
0000     Input Off     Input Always Reads OFF    
0001     Input On     Input Always Reads ON    
0002     PRCM Diagnostic Code     Input Is Normally OFF. Input Is ON When Any PRCM Diagnostic Code Is Detected. (Refer to Troubleshooting, "Troubleshootng Diagnostic Codes" List.)    
Table 2
NUMERIC DISPLAY CODES AND CONNECTION CHART FOR PRCM DISCRETE INPUTS    
Input Code     Identification     40-Pin Connector Contact    
1001     PRCM Switch Input 1     38    
1002     PRCM Switch Input 2     33    
1003     PRCM Switch Input 3     32    
1004     PRCM Switch Input 4     40    
1005     PRCM Switch Input 5     39    
1006     PRCM Switch Input 6     23    
1007     PRCM Switch Input 7     24    
1008     PRCM Switch Input 8     25    Note: Each switch input must be connected to the ground of the switch input in order to activate. A ground point for the PRCM can be obtained at the negative battery post on the relay module. The relay module is located at the rear of the PRCM. Another ground point location is pin contact 31 of the 40 pin connector on the PRCM. Note: Open circuit voltage (input inactive) is approximately 10.5 DCV on all of the switched inputs.
Table 3
DISPLAY CODES FOR INPUTS FROM THE ECM    
Input Code     Parameter    
2000     ECM Active Diagnostic Present    
2001     ECM Active Diagnostic and/or Event Present    
2010     ECM Voltage Warning    
2011     Engine Oil Pressure Warning    
2012     Engine Jacket Water Temperature High Warning    
2013     Engine Jacket Water Temperature Low Warning    
2014     Overspeed Warning    
2015     Air Inlet Restriction Warning    
2016     Exhaust Temperature Warning    
2017     Oil Filter Differential Pressure Warning    
2018     Fuel Filter Differential Pressure Warning    
2019     Crankcase Pressure Warning    
2020     Aftercooler Temperature Warning    
2023     Low Coolant Level Warning    
2024     Low Fuel Level Warning    
2026     Marine Gear Oil Temperature Warning    
2027     Marine Gear Oil Pressure Warning    
2040     Injection Disabled    
2041     Engine At 100 Percent Load Factor    
2042     Engine Speed Above 50 RPM    
2043     Overcrank    
2044     Start Motor Relay Active    
2045     System Not In Auto    
2050     Engine Derated    
2051     Engine Derated, But Not For Altitude    
2070     Engine Monitoring System Shutdown    
2071     Engine Oil Pressure Shutdown    
2072     Engine Jacket Water Temperature Shutdown    
2073     Overspeed Shutdown    
2074     Crankcase Pressure Shutdown    
2075     Aftercooler Temperature Shutdown    
Table 4
NUMERIC DISPLAY CODES FOR THE PRCM LED DISPLAY    
LED CODE     LED IDENTIFICATION    
A001     ALARM 1    
A002     ALARM 2    
A003