MANIFOLD 8E1243 - Caterpillar

Table 1
Display Button Operation for Single Camera Systems
Operation Procedure Notes
Brightness Adjustment Press button 5 in order to enable the "Brightness Adjustment", then press either button 6 or 7 in order to adjust the brightness. If "Auto Brightness "is enabled, the brightness starting set point can be changed by the operator while in the manual or automatic mode.
Press any other display key in order to exit brightness adjustment mode.
Contrast Adjustment Press button 4 in order to enable the Contrast Adjustment, then press either button 6 or 7 in order to adjust the contrast level. Press any other display key in order to exit the contrast adjustment mode.
Automatic Brightness ON/OFF Press button 2 in order to turn the automatic brightness option ON/OFF. When WAVS is placed in the "Automatic Brightness" mode, the display will brighten or dim automatically as the ambient light increases or decreases.
Standby ON/OFF Press button 3 in order to turn the standby option ON/OFF. If the standby mode is ON, the display will remain dark until a WAVS input is detected, however, the power and standby LED should remain on.
LED Indication
If the LED for button 8 and the LED of the camera that is selected (C1, C2, or C3) flash together, the image is switched off because the ambient temperature is below −25 °C (−13°F) or is above 70 °C (158 °F). Multi Camera System
Camera Select - for Multi Camera System
The display is supplied by Caterpillar with the camera select function disabled. The camera select function must be enabled for a multi camera system. With "Camera Select" enabled, individual cameras can be selected, configured, and positioned in order to provide the desired view.In order to enable "Camera Select":
Press and hold button 1 (camera select) and button 4 (contrast), simultaneously for 40 seconds. This will enable the camera select option. After "Camera Select" has been enabled, you will be able to press button 1 (camera select) in order to place the system in "Manual" mode.The LED that is above and to the right of button 1 (camera select) will flash in order to indicate that the system is in manual mode.One of the indicator LED's (C1, C2, or C3) that are to the left of the display buttons will indicate which camera view is displayed. Refer to Illustration 1 (9).
If the machine has a second camera, press button 1 (camera select) again in order to select the next camera that is to be viewed and/or have its settings adjusted.
If the machine has a third camera, press button 1 (camera select) again in order to select the next camera that is to be viewed and/or have its settings adjusted. Press and hold the camera select button for two seconds in order to exit the "Manual" mode.Available Operator Selections for the WAVS Display
The selections that are listed in this section have been made available to the operator of the machine. The selections for the WAVS display can be changed by the operator as needed. Refer to table 2 and to