MANIFOLD AS-EXHAUST 8N2250 - Caterpillar

Required Parts
Table 1
Item Qty Part Description
1 1 9M-5846 Block
2 2 Dealer Fabricated Plate
3 8 8T-9393 Bolt
4 8 267-8821 Washer
5 4 3J-5169 Weld Nut
6 2 387-7536 Plate
7 2 4L-6454 Bolt
8 2 7X-7729 Washer
9 1 387-7535 Plate As Rework Procedure
Illustration 1 g06087345
(1) 9M-5846 Block
(A) 246 mm (9.7 inch)
(B) 5T-0087 Plate As
(W1) 8 mm (0.3 inch) fillet weld on top and bottom of block (1)
Weld block (1) to existing plate assembly (B) in line with existing blocks. Refer to distance (A) shown in Illustration 1 for location.
Illustration 2 g06087348
(2) 387-7537 Plate
(C) 56.6 mm (2.23 inch)
(D) 125 mm (4.9 inch)
(E) 20.5 mm (0.81 inch) diameter (two holes)
(F) 35 mm (1.4 inch)
(G) 75 mm (3.0 inch)
(H) 100 mm (3.9 inch)
(J) HFS on both sides
(K) 5 mm (0.2 inch)
(L) 10.0 2.0 mm (0.39 0.08 inch) radius
(M) 28.3 mm (1.11 inch)
Fabricate two plates (2) based on the dimensions shown in Illustration 2.Note: Use ASTM A656 Grade 50 steel or equivalent to fabricate plates (2).
Illustration 3 g06087349
(2) 387-7537 Plate
(N) 22.80 mm (0.898 inch)
(W2) 5 mm (0. 2 inch) fillet weld all around the outside of plates (2)
( P) 325.50 mm (12.814 inch)
Weld two plates (2) to RH platform (R). Refer to location shown in Illustration 3.
Illustration 4 g06087350
(2) 387-7537 Plate
(3) 8T-9393 Bolt
(4) 267-8821 Washer
(5) 3J-5169 Weld Nut
(6) 387-7536 Plate
Attach one end of each plate (6) to plates (2) using four bolts (3), four washers (4), and four weld nuts (5) as shown in Illustration 4.
Illustration 5 g06087351
(3) 8T-9393 Bolt
(4) 267-8821 Washer
(6) 387-7536 Plate
(7) 4L-6454 Bolt
(8) 7X-7729 Washer
(9) 387-7535 Plate As
Attach other end of each plate (6) to plate assembly (9) using four bolts (3) and four washers (4). Attach plate assembly (9) to the plate assembly (B) by tightening bolts (7) and washers (8) to block (1) and other two existing blocks in the plate assembly (B). Refer to Illustration 5.