MANIFOLD 9G8012 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Item    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Open the left side access door and turn the battery disconnect switch to the OFF position.
Open the hood assembly.
Illustration 1 g03711324
Disconnect hose assemblies (1) and (3) .
Loosen the clamp and remove hose assembly (4) .
Drain the fuel from fuel filters (5). Refer to Operation and Maintenance Manual for the correct procedure.
Use Tooling (A) in order to remove fuel filters (5) .
Remove the bolts and filter base (2) .Installation Procedure
Table 2
Required Tools    
Item    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    
Install fuel filters (5) in the reverse order of removal.
Prime the fuel system. Refer to Operation and Maintenance Manual for the correct procedure.